Engine Control/Fuel System

Fuel pressure test (low pressure system)

6steps
~41min
4/5difficulty
1special tools
Done 0 of 6

Fuel Pressure Test (Low pressure system)

  1. Release the residual pressure in fuel line.

    (Refer to the Fuel Delivery System - Inspection - "Release Residual Pressure in Fuel Line").

  2. Install the Special Service Tool (SST).

    1. Disconnect the fuel feed tube from the delivery pipe.

    2. Install the special service tool for measuring the fuel pressure in between the fuel feed tube and the fuel delivery pipe (Refer to the figure below).

      • For 09353-02100

      • For 0K353-D4100

  3. Inspect fuel leakage on connections among the fuel feed tube, the delivery pipe, and the SST components with ignition "ON".

  4. Measure the fuel pressure.

    1. Start the engine and measure the fuel pressure at idle.

      Fuel Pressure: Over 290 kPa (Over 2.9 bar, Over 2.95 kgf/cm², Over 42.06 psi)

      Fuel
      Pressure
      Cause Related Part
      Too Low Fuel filter clogged Fuel Filter
      Fuel leakage Fuel Pressure Regulator
      Too High Fuel pressure regulator stuck Fuel Pressure Regulator
    2. Stop the engine, and then check for the change in the fuel pressure gauge reading.

      Standard Value: The gauge reading should hold for about 5 minutes after the engine stops

      Fuel Pressure
      (After Engine Stops)
      Cause Related
      Part
      Fuel Pressure Drops Slowly Leakage on injector Injector
      Fuel Pressure Drops Immediately Check valve of fuel pump stuck open Fuel Pump
    3. Switch "OFF" the ignition.

  5. Release the residual pressure in fuel line.

    (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line").

  6. Finish test.

    1. Remove the Special Service Tool (SST) from the low pressure fuel feed tube and the low pressure inlet of high pressure fuel pump.

    2. Connect the low pressure fuel feed tube and the low pressure inlet of high pressure fuel pump.