Kia Stinger CK Quiz
Body (Interior and Exterior)

Glove Box Housing

In this manual: Body (Interior and Exterior)
General Information — 8Maintenance — 27Engine Mechanical System — 47Engine Electrical System — 19Emission Control System — 12Engine Control System/Fuel System — 51Automatic Transmission System — 34All-Wheel Drive (AWD) System — 7Drive Shaft and Axle — 15Suspension System — 25Steering — 8Restraints — 19Brake System — 22Body (Interior and Exterior) — 47Front Seat Belt — 63Body Electrical System — 99Windshield Wiper/Washer — 11Heating, Ventilation, and Air Conditioning — 32
10steps
~60min
3/5difficulty
Done 0 of 10

Components and Component Location

Component Location

1. Glove Box Housing

Repair Procedures

Replacement

  1. Remove the side cover of the airbag [RH] (A) using a trim remover.

  2. Remove the garnish [RH] (A) after loosening the mounting screws.

  3. Pull both side stoppers (B) from the glove box (A).

  4. Remove the air damper (A) from the glove box (B).

  5. Remove the stopper pins (A), then remove the glove box (B).

  6. Separate the protector garnish under the cover [RH] (A).

  7. Disconnect the lamp connector (A), then remove the protector garnish under the cover.

  8. Separate the glove box housing (A) after loosening the mounting screws, bolts and nuts.

  9. Remove the glove box housing after disconnecting the connectors (A), (B).

  10. Install in the reverse order of removal.

Test yourself

A quick Kia Stinger CK quiz: every answer comes with an explanation and a link to the manual page.