Kia Stonic Quiz
Rear Seat

Dachverkleidungseinheit

In this manual: Rear Seat
General Information — 8Maintenance — 31Engine Mechanical — 49Engine Electrical — 15Emission control system — 11Engine Control System/Fuel System — 45Clutch System — 12Manual Transaxle System — 11DCT (Dual Clutch Transmission) System — 16Drive Shafts and Axles — 9Suspension — 16Steering — 10restraint system — 15Braking system — 22Body (Interior and Exterior) — 89Rear Seat — 16Electrical System — 25Electrochromic Interior Rear View Mirror — 64Heating, Ventilation, and Air Conditioning — 31
29steps
~174min
5/5difficulty
02040608010053.940N·mlb·ft
Tightening torque found on this page
Done 0 of 29

Components and Components Location

COMPONENTS LOCATION

1. Headliner assembly

repair procedures

REMOVAL AND INSTALLATION

  1. Remove the front seat.

    (See Front Seat - Front Seat).

  2. Remove the rear seat.

    (Refer to Rear Seat - "Rear Seat")

  3. Remove the front pillar garnish (A) using a trim remover.

  4. Remove the front door sill trim panel (A) using a trim removal tool.

  5. Remove the rear rocker panel trim (A) using a trim removal tool.

  6. Disconnect the front seat belt anchor (B) from the EFD (A).

  7. Remove the center pillar lower trim (A) using a trim removal tool.

8th.

Remove the center pillar upper trim (A) using a trim removal tool.

  1. Remove the luggage compartment cover (A).

  2. Remove the rear cross trim (A) using a trim removal tool.

  3. Loosen the locking screw, then lower the rear seat belt anchor (A) and separate it.

    Tightening torque: 39.2 ~ 54 N·m

  4. Loosen the mounting screws, then remove the luggage compartment side panel (A).

  5. Remove the rear pillar trim (A) using a trim removal tool.

  6. Loosen the screw and remove the sun visor (A).

  7. Loosen the screws, then remove the holder (A).

  8. Disconnect the assist grip caps (A).

  9. Loosen the mounting screws, then remove the passenger side assist grip bracket (A).

  10. Loosen the mounting screws, then remove the overhead console lamp (A).

  11. Disconnect the connector (A) and remove the overhead console lamp.

  12. Remove the room lamp lens (A) using a trim removal tool.

  13. Loosen the screws and remove the room lamp (A).

  14. Disconnect the connector (A) of the map lamp (B) and remove the map lamp.

  15. Remove the ECM mirror cover (A).

  16. Disconnect the ECM mirror connector (A).

  17. Loosen the ECM mirror mounting screw, then press the ECM mirror base upward to remove the mirror assembly (A).

  18. Disconnect the roof connector (A), then remove the mounting clips.

    [DRIVER SIDE]

    [PASSENGER SIDE]

  19. Remove the headliner retaining clips (A).

    (Front)

  20. Disconnect the sunroof motor connector (A).

  21. Remove the headliner assembly (A) from the vehicle through the tailgate.

  22. Installation is the reverse of removal.

Test yourself

A quick Kia Stonic quiz: every answer comes with an explanation and a link to the manual page.