Outside Rear View Mirror

Components and Component Location

Component Location

Repair Procedures

Replacement

1. 1

   Remove the front door trim panel.

   (Refer to Front Door - Front Door Trim Panel)

2. 2

   Using a screwdriver or removal tool, remove the outside rear view mirror cover (A).

   

3. 3

   Disconnect the outside rear view mirror connector (A).

   

4. 4

   After loosening the mounting nuts, remove the outside rearview mirror (A).

   Tightening torque:

   6.9–10.8 N·m (0.7–1.1 kgf·m, 5.1–8.0 ft·lbf, 60.8–95.5 in·lbf)

   

5. 5

   To install, reverse the removal procedure.

Disassembly

[Scalp]

1. 1

   Remove the outside rearview mirror assembly.

   (Refer to Body — "Outside Rearview Mirror")

2. 2

   After inserting a flat-tip screwdriver as shown in the figure below, remove the mirror (A) by applying slight force.

   

3. 3

   Disconnect the heater connector (A) and the rear corner radar indicator connector (B).

   

4. 4

   Remove the scalp.

   1. Apply protective tape to the tip of the screwdriver.

      

   2. Insert the screwdriver where you can see the back of the scalp.

      

5. 5

   Assemble in the reverse order of disassembly.

   (Refer to Body — "Outside Rearview Mirror")

[Housing Cover]

1. 1

   Remove the outside rearview mirror assembly.

   (Refer to Body — "Outside Rearview Mirror")

2. 2

   Insert a flat-tip screwdriver as shown in the illustration below, then remove the mirror (A) by applying a quick force.

   

3. 3

   Disconnect the heater connector (A) and the rear corner radar indicator connector (B).

   

4. 4

   Remove the housing cover mounting screw.

5. 5

   Using a puller, remove the housing cover (A).

   

6. 6

   Assemble in the reverse order of disassembly.