Sunroof

Components and Component Location

Component

Repair Procedures

Alignment

Glass Step Alignment

1. 1

   Perform the major step alignment after replacing the sliding glass (A).

   

   ①
   ②
   ③

2. 2

   Perform height adjustment by slightly loosening the height adjustment screw (A).

   

Motor Initialization

1. 1

   Perform the reset procedure when the ignition is in ON or the engine is running.

2. 2

   Close the sunroof glass (approx. 5 sec) and the sunshade (approx. 5 sec) sufficiently.

3. 3

   Release the adjustment lever when the glass and sunshade are sufficiently closed.

4. 4

   Press the adjustment lever (10 sec) until the glass and sunshade move slightly. Press again in the closing direction when the glass and sunshade are sufficiently closed.

5. 5

   Release, then press the sunroof adjustment lever to close in the direction; the glass and blind then open and close [① Blind opens in slide mode ② Sunroof opens and closes in tilt-after-slide mode ③ Blind closes] Initialization is complete. Never release the adjustment lever until the procedure is fully completed.

When Initializing the Motor

1. 1

   First Operation After Manufacture

2. 2

   When the residual value has been initialized or damaged by a power failure or discharge

3. 3

   After Using the Emergency Handle

4. 4

   When Replacing the Battery and Fuse

5. 5

   After Replacing the Motor and Repairing the Sunroof

Emergency Operation

1. 1

   Emergency operation of the sunroof is not permitted, except for closing or opening the sunroof when the motor is faulty.

2. 2

   Close or open the sunroof only after removing the headliner trim using a hex key. Do not apply excessive force.

3. 3

   If necessary, perform initialization according to the initialization procedure.

   [Sliding Glass Motor (A), Blind Motor (B)]