Kia Optima DL3 Quiz
Body (Interior and Exterior)

Rear Bumper Beam Assembly

In this manual: Body (Interior and Exterior)
General Information — 8Advanced Driver Assistance System (ADAS) — 21Maintenance — 27Engine Mechanical System — 45Engine Electrical System — 11Emission Control System — 11Engine Control System/Fuel System — 25Automatic Transmission — 20Drive Shaft and Axle — 7Suspension System — 22Steering — 7Restraints — 11Brake System — 22Body (Interior and Exterior) — 116Body Electrical System — 90Heating, Ventilation, and Air Conditioning — 32
4steps
~24min
2/5difficulty
Done 0 of 4

Components and Component Location

Component Location

1. Rear bumper beam assembly

Repair Procedures

Replacement

  1. Remove the rear bumper assembly.

    (Refer to Rear Bumper - "Rear Bumper Assembly")

  2. Disconnect the rear bumper wiring harness clamps (A).

  3. Loosen the mounting clips, press the lock pin, and remove the rear bumper beam assembly (A).

  4. To install, reverse the removal procedure.

Test yourself

A quick Kia Optima DL3 quiz: every answer comes with an explanation and a link to the manual page.