AVN Remote Control

Components and Component Location

Components

Circuit Diagrams

Wiring Diagram

[Audio]

[Audio + Bluetooth]

[Audio + Bluetooth + Voice]

[Mute (2 buttons) + LCD Cluster SEG]

[Off (2 buttons) + ACC]

[Off (2 buttons) + ACC + SLD]

[Mute (4 buttons) + DOT&TFT LCD Panel]

[Off (4 buttons) + ACC]

[Off (4 buttons) + ACC + SLD]

Repair Procedures

Removal

1. 1
   Disconnect the negative (-) battery terminal.
2. 2
   Remove the steering wheel assembly. (Refer to Steering System – Steering Wheel)
3. 3
   Remove the remote control from the steering wheel (A) after loosening the mounting screws. [Left]

   

   

   [RH]

   

   

4. 4
   Disconnect the remote control switch connector on the steering wheel (A). [Left]

   

   [RH]

   

Installation

1. 1
   Connect the remote control switch connector on the steering wheel.
2. 2
   Install the remote control switch on the steering wheel.
3. 3
   Install the steering wheel and the driver airbag module.
4. 4
   Connect the negative (-) battery terminal.

Inspection

1. 1
   Check the resistance between terminals at each switch position (LH).

   

   [L: Audio + Hands-free + Voice]

   Switch	Connector Terminal	Resistance (±3%)
   SEEK UP	1-6	430 Ω
   SEEK DOWN		1.11 kΩ
   MODE		2.11 kΩ
   MUTE		3.11 kΩ
   VOL (+)		4.61 kΩ
   VOL (-)		6.81 kΩ
   Voice		10.71 kΩ
   END		18.91 kΩ
   SEND		40.91 kΩ

2. 2
   Check the resistance between terminals at each switch position (RH).

   

   [RH: Cruise + Trip]

   Switch	Connector Terminal	Resistance (±3%)
   Cancel	2-6	390 Ω
   SET -		610 Ω
   VOICE +		910 Ω
   CRUISE ON/OFF		1.38 kΩ
   Cruise and Speed Limiter ON/OFF		2.13 kΩ
   SCC (Smart Cruise Control)		3.63 kΩ
   GROUP	1-6	390 Ω
   STEP		610 Ω
   TRIP DOWN		910 Ω
   ENTER		1.38 kΩ