Kia Picanto JA Quiz
Body Electrical System

Rear Combination Lamp

In this manual: Body Electrical System
General Information — 8Maintenance — 30Engine Mechanical System — 46Engine Electrical System — 14Emission Control System — 11Engine Control System/Fuel System — 46Clutch System — 12Manual Transmission — 10Drive Shaft and Axle — 8Suspension System — 15Steering — 9Restraints — 17Brake System — 22Body (Interior and Exterior) — 104Body Electrical System — 80Heating, Ventilation, and Air Conditioning — 17
19steps
~114min
4/5difficulty
Done 0 of 19

Repair Procedures

Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the rear combination lamp (A) after loosening the screws.
  3. Remove the rear combination lamp seal (A).
  4. Disconnect the rear combination lamp connector (A).
  5. Disconnect the negative (-) battery terminal.
  6. Remove the rear bumper assembly. (Refer to Body - "Rear Bumper Assembly")
  7. Disconnect the back-up lamp connector (A).
  8. Remove the back-up lamp (A) after loosening the screws.
Back-up Lamp

Bulb Replacement

Turn Signal Indicator
  1. Remove the rear combination lamp.
  2. Remove the turn signal lamp (B) by turning the socket (A) counterclockwise.
  3. Remove the rear wheel.
  4. Remove the rear wheel guard (A) after loosening the mounting screws and clips.
  5. Remove the back-up lamp bulb (B) by turning the socket (A) counterclockwise.
Back-up Lamp

Installation

Rear Combination Lamp
  1. Connect the rear combination lamp connector.
  2. Install the rear combination lamp.
  3. Connect the negative (-) battery terminal.
  4. Install the back-up lamp.
  5. Install the rear bumper assembly.
  6. Connect the negative (-) battery terminal.
Back-up Lamp

Test yourself

A quick Kia Picanto JA quiz: every answer comes with an explanation and a link to the manual page.