Kia Rio YB Quiz
Brake System

Brake Pedal

In this manual: Brake System
General Information — 8Maintenance — 31Engine Mechanical System — 44Engine Electrical System — 14Emission Control System — 9Engine Control System/Fuel System — 30Clutch System — 10Manual Transmission — 10Automatic Transmission — 23Drive Shaft and Axle — 8Suspension System — 15Steering — 9Restraints — 14Brake System — 22Body (Interior and Exterior) — 115Body Electrical System — 84Heating, Ventilation, and Air Conditioning — 28
8steps
~48min
2/5difficulty
0102030405025.519N·mlb·ft
Tightening torque found on this page
Done 0 of 8

Components and Component Location

Components

1. Brake Pedal Assembly
2. Stop Lamp Switch		 3. Pedal Assembly

Repair Procedures

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery terminal.

  2. Remove the airbag lower panel.

    (Refer to Body - "Under Cover Panel")

  3. Disconnect the brake switch connector (A).

  4. Disconnect the lock pin (A) and the flat head pin (B).

  5. Remove the brake pedal mounting nuts (A).

    Tightening torque: 16.7–26 N·m

Inspection

  1. Inspect the bushing for wear.

  2. Inspect the brake pedal for bending or twisting.

  3. Inspect the brake pedal return spring for damage.

Installation

  1. Install in the reverse order of removal.

Test yourself

A quick Kia Rio YB quiz: every answer comes with an explanation and a link to the manual page.