Brake Line

Components and Component Location

Components

Repair Procedures

Removal

1. 1

   Disconnect the brake fluid level switch connector (A), then remove the reservoir cap.

   

2. 2

   Remove the front/rear wheel and tire.

   Tightening torque: 107.9–128 N·m

   

3. 3

   Remove the brake hose clamp (A).

4. 4

   Disconnect the brake tube by loosening the tube flare nut (B).

   Tightening torque: 13.7–16.7 N·m

   

   

5. 5

   Disconnect the brake hose from the brake caliper by loosening the bolt (A).

   Tightening Torque: 24.5–29 N·m

   

   

Inspection

1. 1

   Inspect the brake tubes for cracks, bends and corrosion.

2. 2

   Inspect the brake hoses for cracks, damage and fluid leaks.

3. 3

   Inspect the tube flare nuts for damage and fluid leaks.

4. 4

   Inspect the brake hose mounting bracket for cracks or deformation.

Installation

1. 1

   Install in the reverse order of removal.

2. 2

   After installation, bleed the brake system.

   (Refer to Brake System - "Brake System")

3. 3

   Inspect for spilled brake fluid.