Kia Rio YB Quiz

Exterior lighting

In this manual: Exterior lighting
Maintenance and Service — 0Driving the vehicle — 0Getting to know your vehicle — 0Vehicle security systems — 0Introduction — 0Vehicle exterior — 0Emergency Procedures — 0Infants and small children — 0Older children — 0Pregnant women — 0Injured persons — 0Airbag crash sensors — 0Airbag deployment conditions — 0Airbag non-deployment conditions — 0Battery saver function — 0Follow Me Home function (if equipped) — 0Headlamp welcome function (if equipped) — 0Light control — 0High beam operation — 0Front fog lights (if equipped) — 0Rear Fog Light — 0Headlight Beam Leveling Device (if equipped) — 0Battery saver function — 0Follow Me Home function (if equipped) — 0Headlamp welcome function (if equipped) — 0Light control — 0High beam operation — 0Front fog lights (if equipped) — 0Rear Fog Light — 0Headlight Beam Leveling Device (if equipped) — 0Replacing the Headlight, Parking Light, Turn Signal Light, or Front Fog Light Bulb — 0Headlight beam leveling for headlights and front fog lights — 0Turn signal light bulb replacement — 0Rear combination lamp bulb replacement — 0Additional brake light replacement (if equipped) — 0Interior lamp bulb replacement — 0
9steps
~54min
2/5difficulty
Done 0 of 9
Oświetlenie na zewnątrz

Rear turn signal/stop light and tail light

  1. Switch off the engine.
  2. Open the engine compartment cover.
  3. Loosen the lamp assembly retaining screws with a Phillips screwdriver.
  4. Remove the rear combination lamp assembly from the vehicle body.
    Światło tylnego kierunkowskazu/stopi i światło tylne

  1. Remove the bulb holder from the assembly by turning it counterclockwise until the tabs on the bulb holder line up with the cutouts in the assembly.
  2. Remove the bulb from the holder by pushing it in and turning it counterclockwise until the tabs on the bulb line up with the slots in the holder. Pull the bulb out of the holder.
  3. Install the new bulb by inserting it into the holder and turning it until it locks in place.
  4. Install the bulb holder in the assembly by aligning the tabs on the holder with the slots in the assembly. Push the holder into the assembly and turn it clockwise.
  5. Reinstall the lamp assembly on the vehicle body.

Test yourself

A quick Kia Rio YB quiz: every answer comes with an explanation and a link to the manual page.