Kia Rio YB Quiz
Automatic Transmission

Output Speed Sensor

In this manual: Automatic Transmission
General Information — 8Maintenance — 31Engine Mechanical System — 44Engine Electrical System — 14Emission Control System — 9Engine Control System/Fuel System — 30Clutch System — 10Manual Transmission — 10Automatic Transmission — 23Drive Shaft and Axle — 8Suspension System — 15Steering — 9Restraints — 14Brake System — 22Body (Interior and Exterior) — 115Body Electrical System — 84Heating, Ventilation, and Air Conditioning — 28
2steps
~12min
1/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 2

Specifications

Specification

Item Specification
Type Hall Effect Sensor
Current 22 mA (max.)
Output Voltage High: 4.8 V - 5.2 V
Low: Below 0.8

Description and Operation

Description

  • Measures the rotational speed of the output shaft inside the transmission and sends the reading to the TCM.

  • The sensor provides important inputs used in feedback control, torque converter clutch control, shift control, line pressure control, clutch pressure activation control, and sensor malfunction analysis.

Circuit Diagrams

Wiring Diagram

Repair Procedures

Inspection

  1. Check the output speed sensor signal waveform using KDS/GDS.

Low speed

High speed

Removal

  1. Disconnect the output speed sensor connector (A).

  2. Remove the output speed sensor (A).

    Tightening Torque: 9.8–11.8 N·m

Installation

  1. Install in the reverse order of removal.

Test yourself

A quick Kia Rio YB quiz: every answer comes with an explanation and a link to the manual page.