Kia Rio YB Quiz
Body (Interior and Exterior)

Rear Bumper Assembly

In this manual: Body (Interior and Exterior)
General Information — 8Maintenance — 31Engine Mechanical System — 44Engine Electrical System — 14Emission Control System — 9Engine Control System/Fuel System — 30Clutch System — 10Manual Transmission — 10Automatic Transmission — 23Drive Shaft and Axle — 8Suspension System — 15Steering — 9Restraints — 14Brake System — 22Body (Interior and Exterior) — 115Body Electrical System — 84Heating, Ventilation, and Air Conditioning — 28
10steps
~60min
3/5difficulty
Done 0 of 10

Components and Component Location

Component Location

1. Rear bumper cover

Repair Procedures

Replacement

  1. Separate the rear combination lamp (A) after loosening the mounting screws.

  2. Disconnect the waterproof seal (A).

  3. Disconnect the rear combination lamp connector (A).

  4. Loosen the upper rear bumper fastener.

  5. Remove the rear bumper side lower cover after loosening the nut and clips.

  6. Remove the side part of the rear bumper after loosening the mounting screws.

  7. Disconnect the rubber mounts (A) from the muffler (B).

  8. Loosen the mounting bolts.

    [LH]

    [RH]

  9. Remove the rear bumper after disconnecting the rear bumper wiring connector (A).

  10. Install in the reverse order of removal.

Test yourself

A quick Kia Rio YB quiz: every answer comes with an explanation and a link to the manual page.