Kia Rio YB Quiz
Body (Interior and Exterior)

Rear Seat Back Cover

In this manual: Body (Interior and Exterior)
General Information — 8Maintenance — 31Engine Mechanical System — 44Engine Electrical System — 14Emission Control System — 9Engine Control System/Fuel System — 30Clutch System — 10Manual Transmission — 10Automatic Transmission — 23Drive Shaft and Axle — 8Suspension System — 15Steering — 9Restraints — 14Brake System — 22Body (Interior and Exterior) — 115Body Electrical System — 84Heating, Ventilation, and Air Conditioning — 28
27steps
~162min
5/5difficulty
Done 0 of 27

Components and Component Location

Component Location

1. Rear Seat Back Trim [LH] 2. Rear Seat Back Trim [RH]

Repair Procedures

Replacement

[LH]

  1. Remove the rear seat assembly.

    (Refer to Rear Seat - "Rear Seat Assembly")

  2. Press the stopper pin and remove the rear seat headrest (A).

  3. Remove the rear seatback belt guide (A) using a trim removal tool.

  4. Remove the upper face panel cover (A) using a trim removal tool.

  5. Remove the child anchor cover (A) using a removal tool.

  6. Disconnect the rear seat back dust cover (A).

  7. Remove the ring clips (A).

  8. Unzip the side zipper of the seat back (A).

  9. Remove the rear panel (A) after removing the clips.

  10. Remove the rear cover mounting clips (A).

  11. Press the rear seat headrest guides (A) while squeezing both sides of the headrest. Lower the guides and remove them.

  12. Remove the rear seatback trim from the frame.

  13. Remove the front seatback trim (C) after removing the hook-and-loop tape (A) and the ring clip (B).

  14. Install in the reverse order of removal.

[RH]

  1. Remove the rear seat assembly.

    (Refer to Rear Seat - "Rear Seat Assembly")

  2. Press the stopper pin and remove the rear seat headrest (A).

  3. Remove the upper face panel cover (A) using a trim removal tool.

  4. Remove the child anchor cover (A) using a removal tool.

  5. Disconnect the rear seat back dust cover (A).

  6. Remove the ring clips (A).

  7. Unzip the side zipper of the seat back (A).

  8. Remove the rear panel (A) after removing the clips.

  9. Remove the rear cover mounting clips (A).

  10. Press the rear seat headrest guides (A) while squeezing both sides of the headrest. Lower the guides and remove them.

  11. Remove the rear seatback trim from the frame.

  12. Remove the front seatback trim (C) after removing the hook-and-loop tape (A) and the ring clip (B).

  13. Install in the reverse order of removal.

Test yourself

A quick Kia Rio YB quiz: every answer comes with an explanation and a link to the manual page.