Body Exterior, Doors, Roof & Vehicle Security

Calibration of Automatic Back Door Position Information

5steps
~30min
2/5difficulty
Done 0 of 5

Description

When the following work is performed, it is necessary to perform initial setting of automatic back door position information to operate automatic back door system. Refer to Work Procedure.

  • After removing and installing, or replacing back door assembly

  • After removing and installing, or replacing spindle unit

Work Procedure

STEP 1

  1. Select “AUTOMATIC BACK DOOR” using CONSULT.

  2. Select “Reset auto back door status” of “WORK SUPPORT” mode.

  3. Touch “Initialize” to erase automatic back door position information.

>>

GO TO 2.

STEP 2

Fully close the back door manually.

>>

GO TO 3.

STEP 3

Operate back door opener switch and perform automatic open operation.

>>

GO TO 4.

STEP 4

  1. The back door fully opens.

  2. Check that automatic back door warning buzzer sounds normally.

Does automatic back door warning buzzer sound normally?

YES>>

GO TO 5.

NO>>

GO TO 2.

STEP 5

Fully close the back door.

>>

WORK END