Body Exterior, Doors, Roof & Vehicle Security

Door Does Not Lock/unlock and Engine Does Not Start (req Sw/push Sw) (all Keys)

6steps
~36min
2/5difficulty
Done 0 of 6

Description

All doors do not lock/unlock using door request switch, and engine does not start when push-button ignition switch is pressed while carrying Intelligent Key.

SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS)

Door lock operation (remote keyless entry)Door lock operation (one touch sensor or request switch of front/rear/back door) or trunk/back door open operation (opener switch of trunk/back door panel)Engine started with push-button ignition switch operation (registered Intelligent Key is within the detection area of inside key antenna)Engine started with push-button ignition switch operation (registered Intelligent Key placed next to push-button ignition switch)Unlock operation when approaching the vehicle, lock operation when away from the vehicle (registered Intelligent Key is within the detection area of outside key antenna)
OK NG No crank, No start OK OK

DIAGNOSIS PROCEDURE

Refer to Diagnosis Procedure.

Diagnosis Procedure

CHECK INTELLIGENT KEY SYSTEM SYMPTOM TABLE

Check Intelligent Key system symptom table.

Refer to Diagnosis Procedure.

>>

GO TO 2.

CHECK INSIDE KEY ANTENNA

Check inside key antenna.

  • NATS antenna amp.: Refer to DTC Diagnosis Procedure.

  • Console: Refer to DTC Diagnosis Procedure.

  • Luggage room: Refer to DTC Diagnosis Procedure.

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace the malfunctioning parts.

CHECK OUTSIDE KEY ANTENNA

Check outside key antenna.

  • Rear door LH: Refer to DTC Diagnosis Procedure.

  • Rear door RH: Refer to DTC Diagnosis Procedure.

  • Rear bumper: Refer to DTC Diagnosis Procedure.

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Repair or replace the malfunctioning parts.

REGISTER INTELLIGENT KEY

  1. Register the Intelligent Key again.

  2. Check operation after replacement.

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

GO TO 5.

REPLACE INTELLIGENT KEY

  1. Replace the Intelligent Key and perform registration again.

  2. Check operation after replacement.

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

GO TO 6.

REPLACE INTELLIGENT KEY UNIT

  1. Replace Intelligent Key unit. Refer to Removal and Installation.

  2. Check operation after replacement.

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Check intermittent incident. Refer to Intermittent Incident.