Hood Lock
Exploded View

| Hood lock assembly | Hood lock control cable assembly | Hood lock control handle | |||
| : Clip | |||||
| : Pawl | |||||
| : N·m (kg-m, in-lb) | |||||
| : Body grease | |||||
Hood Lock Assembly
Removal and Installation
REMOVAL
Remove front grille upper. Refer to Removal and Installation (OFF ROAD MODELS) or Removal and Installation (CITY MODELS).
Disconnect hood lock switch harness connector (if equipped).
Remove hood lock assembly mounting bolts, and then remove hood lock assembly.
Disconnect hood lock control cable assembly from hood lock according to the numerical order 1→2 indicated by arrows as shown in figure.

INSTALLATION
Note the following items, and then install in the reverse order of removal.
Inspection
Check that secondary latch is securely engaged with bracket from dead load of hood assembly.
Check that primary latch
is securely engaged with hood striker
when hood assembly is closed [freefall from approximately 200 mm (7.87 in) height].

While operating the hood lock control handle carefully, check that the front end of the hood is lifted by approximately 20 mm (0.79 in) (C). Also, check that the hood lock control handle returns to the original position.

| Hood striker | Primary latch |
Check that operating force of hood lock control handle shall be less than 49 N (5.0 kg, 11.0 lb).
Check pitch that secondary latch
is properly engaged with hood striker
[8.1 mm (0.319 in) MIN] (D).

Install so that static closing force of hood is 490 N (50.0 kg, 110.0 lb) or Less.
Check the hood lock assembly lubrication condition. If necessary, apply body grease to hood lock assembly.

| : Body grease |
Hood Lock Control Handle
Removal and Installation
REMOVAL
Disengage hood lock control handle fixing pawl, and then remove hood lock control handle.

| : Pawl |
INSTALLATION
Note the following items, and then install in the reverse order of removal.
Hood Lock Control Cable Assembly
Removal and Installation
REMOVAL
Disconnect hood lock control cable assembly from hood lock assembly. Refer to Removal and Installation.
Disengage hood lock control cable assembly fixing clips.
Remove hood lock control handle. Refer to Removal and Installation.
Remove dash side finisher LH. Refer to Removal and Installation.
Remove hood lock control cable assembly mounting bolt.
Remove grommet of the lower dash, and pull the hood lock control cable assembly toward inside vehicle.
INSTALLATION
Note the following items, and then install in the reverse order of removal.