Rear Door Lock
Exploded View

| Rear door outside handle | Escutcheon cover | Escutcheon base | |||
| Rear gasket | Rear door outside handle bracket | TORX bolt | |||
| TORX bolt | Rear door lock assembly | Inside handle cap | |||
| Rear door inside handle | Rear door outside handle cable clip | TORX bolt | |||
| Front gasket | |||||
| : Clip | |||||
| : Pawl | |||||
| : Always replace after every disassembly. | |||||
| : N·m (kg-m, in-lb) | |||||
| : Body grease | |||||
Rear Door Lock Assembly
Removal and Installation
REMOVAL
Remove rear door finisher. Refer to Removal and Installation.
Disconnect rear door lock assembly harness connector.
Disengage rear door lock knob cable fixing clip.
Remove rear door inner frame rear. Refer to Removal and Installation.
Remove rear door outside handle bracket. Refer to Removal and Installation.
Rear door lower sash lower. Refer to Removal and Installation.
Remove rear door lock assembly mounting TORX bolts.
Disengage rear door lock assembly fixing pawls, and then remove rear door lock assembly.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
Inspection
After opening and closing the door, check that door is fixed to the vehicle body normally.
Check the lock/unlock operation of door lock.
Rear Door Inside Handle
Removal and Installation
REMOVAL
Remove rear door finisher. Refer to Removal and Installation.
Remove rear door inside handle fixing screws
.

Remove rear door inside handle fixing pawls, and then remove rear door inside handle.

| :Pawl |
INSTALLATION
Note the following items, and then install in the reverse order of removal.
Rear Door Outside Handle
Removal and Installation
REMOVAL
Remove rear door finisher. Refer to Removal and Installation.
Remove rear door inner frame. Refer to Removal and Installation.
Disconnect rear door outside handle harness connector
, and then disengage rear door outside handle harness connector fixing clip
(if equipped).

| : vehicle front |
Apply protective tape (A) on the part to protect it from damage.

Insert a remover tool (A) at the notch
of the escutcheon cover bottom and disengage fixing pawls, and then remove escutcheon cover.

| : Pawl |
Slide rear door outside handle grip toward rear of vehicle and remove it according to the numerical order 1→2 indicated by arrows as shown in figure.


Remove door side grommet
.

Loosen TORX bolt
from grommet hole.

Remove escutcheon base from rear door panel.

Disengage front gasket
and rear gasket
fixing pawls, and then remove front gasket and rear gasket.

| : Pawl |
Disengage rear door outside handle cable from rear door outside handle cable clip.
Loosen rear door outside handle bracket mounting TORX bolt
.

Slide rear door outside handle bracket
toward front of vehicle and remove it.

| : vehicle front |
Disconnect rear door outside handle cable from rear door outside handle bracket according to the numerical order 1→3 indicated by arrows as shown in figure.

INSTALLATION
Note the following items, and then install in the reverse order of removal.