Engine Mechanical K9K
Glow plug
In this manual: Engine Mechanical K9K
~1min read
Exploded View

1. Glow plug
Engine front
: N·m (kg-m, ft-lb)
Removal and Installation
REMOVAL
CAUTION:Remove glow plug only if necessary. If carbon adheres, it may be stuck and broken. 1. Disconnect the battery cable from the negative terminal. 2. Remove cowl top extension. Refer to EXT-20, "Exploded View". 3. Remove engine under cover. 4. Remove turbocharger air inlet pipe. Refer to EM-280, "Exploded View". 5. Remove air inlet tube assembly and air inlet tube. Refer to EM-281, "Exploded View". 6. Remove High pressure protection cover (upper). Refer to EM-294, "Exploded View". 7. Disconnect harness connector from glow plug.
8. Remove glow plug.
CAUTION:• When removing or installing, never use such tools as an air impact wrench.
• Handle it carefully without giving any impact, even after removal. [As a guide, if it drops from height of 10 cm (3.94 in) or higher, always replace it.]
INSTALLATION
1. Remove adhered carbon from glow plug installation hole with a reamer. 2. Install glow plug.3. Install remaining parts in reverse order of removal.
Was this page helpful?