Engine Mechanical K9K
Rocker cover
In this manual: Engine Mechanical K9K
~1min read
Exploded View

1. Blow-by hose
2. Rocker cover
3. Gasket
4. Camshaft position sensor 5. O-ring
A. To turbocharger air inlet pipe
: N·m (kg-m, in-lb)
: Always replace after every
disassembly.
Removal and Installation
REMOVAL
1. Remove air cleaner case. Refer to EM-280, "Exploded View". 2. Remove inlet pipe assembly and air inlet tube. Refer to EM-281, "Exploded View". 3. Remove high pressure protection cover (upper). Refer to EM-294, "Exploded View". 4. Remove electric throttle control actuator. 5. Remove fuel injector. Refer to EM-294, "Exploded View".6. Remove rocker cover.
• Loosen holding bolts in the reverse order as shown in the figure and remove.
: Engine front

INSTALLATION
1. Apply liquid gasket on locations shown in the figure.
• Use Genuine Liquid gasket or equivalent.

2. Tighten holding bolts in the numerical order as shown in the figure.
: Engine front
: 12 N·m
3. Install in the reverse order of removal after this steps.

Was this page helpful?