Transaxle & transmissioN CVT: RE0F11A
Output speed sensor
In this manual: Transaxle & transmissioN CVT: RE0F11A
~1min read
Exploded View

1. Transaxle assembly 2. Output speed sensor
3. O-ring
disassembly.
: N·m (kg-m, in-lb)
: Genuine NISSAN CVT Fluid NS-2
Removal and Installation
REMOVAL
1. Disconnect battery cable from negative terminal. Refer to PG-124, "Removal and Installation".2. Disconnect the output speed sensor connector.
NOTE:
Lift up the vehicle and perform the work from rear of the unit.
4. Remove the O-ring from the output speed sensor.
INSTALLATION
Note the following, and install in the reverse order of removal.
CAUTION:• Never reuse O-ring.
• Apply Genuine NISSAN CVT Fluid NS-2 to the O-ring.
Inspection and Adjustment
INSPECTION AFTER INSTALLATION
Check for CVT fluid leakage. Refer to TM-480, "Inspection".
ADJUSTMENT AFTER INSTALLATION
Check the CVT fluid level. Refer to TM-379, "Adjustment".
Was this page helpful?