Water hose
Exploded View

1. Hose clamp
2. Water hose A
3. Water hose B
4. Water hose B
5. Water bypass pipe
6. Hose clamp
7. Heater hose
8. Water hose C
A. Water outlet
B. Heater thermostat
C. Oil warmer
D. Heater core
: N·m (kg-m, in-lb)
Removal and Installation
REMOVAL
WARNING:Never remove the radiator cap when the engine is hot. Serious burns could occur from high pressure coolant escaping from the radiator. CAUTION:
Perform these steps after the coolant temperature has cooled sufficiently. 1. Remove the hose clamp and pull out the water hose A. 2. Remove the hose clamp and pull out the water hose B. 3. Remove the hose clamp and pull out the water hose C. 4. Pull out the heater hose and remove the water bypass pipe. Refer to CO-52, "Exploded View".
5. Remove the bracket.
INSTALLATION
Note the following, and install in the reverse order of removal.
• To install bracket to the CVT assembly, face the from arrow (A) of the bracket ahead of the vehicle.

• When installing water hose (1) to tube (2), refer to insertion length “A” below.
Insertion length “A” : 27 mm (1.06 in)

• When hose clamp (1) is installed on CVT water hose (2), refer to dimension “A” below.
Dimension“A” : 5 – 7 mm (0.20 – 0.28 in)
• The hose clamp should not come on bulge (B).


Inspection
INSPECTION AFTER INSTALLATION
Start the engine, and check the joints for coolant leakage.