Transaxle & transmissioN CVT: RE0F11A
Primary speed sensor
In this manual: Transaxle & transmissioN CVT: RE0F11A
~1min read
Exploded View

1. Transaxle assembly 2. O-ring
3. Primary speed sensor
disassembly.
: N m (kg-m, in-lb)
: Genuine NISSAN CVT Fluid NS-2
Removal and Installation
REMOVAL
1. Remove the battery. Refer to PG-124, "Removal and Installation". 2. Remove the air cleaner case. Refer to EM-161, "Removal and Installation". 3. Remove the ECM and bracket as a set. 4. Disconnect the primary speed sensor connector. 5. Remove the primary speed sensor.6. Remove the O-ring from the primary speed sensor.
INSTALLATION
Note the following, and install in the reverse order of removal.
CAUTION:• Never reuse O-ring.
• Apply Genuine NISSAN CVT Fluid NS-2 to the O-ring.
Inspection and Adjustment
INSPECTION AFTER INSTALLATION Check for CVT fluid leakage. Refer to TM-480, "Inspection".
ADJUSTMENT AFTER INSTALLATION Adjust the CVT fluid level. Refer to TM-379, "Adjustment".
Was this page helpful?