C1109 Power and Ground System
DTC DETECTION LOGIC
| DTC No. | CONSULT screen item (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| C1109 | BATTERY VOLTAGE [ABNORMAL] (Battery voltage [abnormal]) |
Diagnosis condition | When ignition switch ON. |
| Signal (terminal) | Ignition power supply | ||
| Threshold | When ignition power supply voltage out of range. | ||
| Diagnosis delay time | 5 second or more | ||
POSSIBLE CAUSE
| PAST DTC | CRNT DTC |
|---|---|
|
|
FAIL-SAFE
The following functions are suspended:
VDC function
TCS function
ABS function
EBD function
Brake assist function
Hill start assist function
PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF and wait at least 10 seconds before conducting the next test.
>>GO TO 2.
CHECK DTC DETECTION
CONSULT
Ignition switch OFF.
Start the engine.
Select “Self Diagnostic Result” mode of “ABS”.
Is DTC “C1109” detected?
YES>>“CRNT” is displayed: Proceed to DTC Diagnosis Procedure.
YES>>“PAST” is displayed: Inspection End. (Erase the memory of “Self Diagnostic Result” mode of “ABS”.)
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
CHECK CONNECTOR
Ignition switch OFF.
Check the ABS actuator and electric unit (control unit) harness connector for disconnection or looseness.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair / replace harness or connector, securely lock the connector, and GO TO 2.
PERFORM SELF DIAGNOSTIC RESULT
Ignition switch OFF.
Start the engine.
Select “Self Diagnostic Result” mode of “ABS”.
Is DTC “C1109” detected?
YES>>GO TO 3.
NO>>Inspection End.
CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) POWER SUPPLY AND GROUND CIRCUIT
Check the ABS actuator and electric unit (control unit) power supply and ground circuit. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 4.
NO>>Repair / replace harness, connector, fuse, or fusible link.
CHECK TERMINAL
Check the ABS actuator and electric unit (control unit) pin terminals for damage or loose connection with harness connector.
Check the IPDM E/R pin terminals for damage or loose connection with harness connector.
Is the inspection result normal?
YES>>Replace the ABS actuator and electric unit (control unit). Refer to Removal and Installation.
NO>>Repair / replace harness, connector, or terminal.