Brakes

C1144 Incomplete Steering Angle Sensor Adjustment

10steps
~60min
3/5difficulty
Done 0 of 10
DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen item

(Trouble diagnosis content)
DTC detected condition
C1144

ST ANG SEN SIGNAL

(Steering angle sensor not complete)
Diagnosis condition
  • When ignition switch ON.

  • When power supply voltage is normal.

Signal (terminal) —
Threshold When neutral position adjustment of steering angle sensor is not complete.
Diagnosis delay time 1 second or less

POSSIBLE CAUSE

PAST DTCCRNT DTC
Incomplete neutral position adjustment of steering angle sensor
  • Harness or connector

  • Steering angle sensor

  • ABS actuator and electric unit (control unit)

  • Incomplete neutral position adjustment of steering angle sensor

FAIL-SAFE

The following functions are suspended:

  • VDC function

  • TCS function

  • Hill start assist function

DTC Confirmation Procedure

PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF and wait at least 10 seconds before conducting the next test.

>>

GO TO 2.

CHECK DTC DETECTION

CONSULT

  1. Ignition switch OFF.

  2. Start the engine.

  3. Select “Self Diagnostic Result” mode of “ABS”.

Is DTC “C1144” detected?

YES>>

“CRNT” is displayed: Proceed to DTC Diagnosis Procedure.

YES>>

“PAST” is displayed: Inspection End (Erase the memory of “Self Diagnostic Result” mode of “ABS”.)

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

ADJUST THE NEUTRAL POSITION OF STEERING ANGLE SENSOR

Perform neutral position adjustment of steering angle sensor. Refer to Description.

>>

GO TO 2.

CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)

CONSULT

  1. Ignition switch OFF.

  2. Start the engine.

  3. Select “Self Diagnostic Result” mode of “ABS”.

Is DTC “C1144” detected?

YES>>

GO TO 3.

NO>>

Inspection End.

CHECK STEERING ANGLE SENSOR SYSTEM

  1. Ignition switch OFF.

  2. Check the steering angle sensor system. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Repair / replace harness, connector, or terminal.

CHECK DATA MONITOR

CONSULT

  1. Select “STR ANGLE SIG” in “Data Monitor” mode of “ABS”.

  2. Check that the indication changes with the steering angle when the steering wheel is turned left/right from the neutral position. Refer to Values on the Diagnosis Tool.

Is the inspection result normal?

YES>>

Replace the ABS actuator and electric unit (control unit). Refer to Removal and Installation.

NO>>

Replace the steering angle sensor. Refer to Removal and Installation.