Brakes

Parking Brake Switch

12steps
~72min
3/5difficulty
Done 0 of 12
Component Function Check

CHECK PARKING BRAKE SWITCH OPERATION

Check that brake warning lamp in combination meter turns ON/OFF when parking brake is operated.

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Proceed to Diagnosis Procedure.

Diagnosis Procedure

CHECK PARKING BRAKE SWITCH CIRCUIT

  1. Ignition switch OFF.

  2. Disconnect parking brake switch harness connector.

  3. Disconnect combination meter harness connector.

  4. Check the continuity between parking brake switch harness connector and combination meter harness connector.

    Parking brake switchCombination meterContinuity
    ConnectorTerminalConnectorTerminal
    E52 1 M24 26 Yes
  5. Check the continuity between parking brake switch harness connector and ground.

    Parking brake switch—Continuity
    ConnectorTerminal
    E52 1 Ground No

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace error-detected parts.

CHECK PARKING BRAKE SWITCH

Check the parking brake switch. Refer to Component Inspection.

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Replace the parking brake switch. Refer to Exploded View.

CHECK PARKING BRAKE SWITCH SIGNAL

CONSULT

  1. Select “PKB SW” in “Data Monitor” mode of “METER/M&A”.

  2. Check that the function operates normally according to the following conditions:

    ConditionData Monitor
    Operate parking brake On
    Release parking brake Off

Is the inspection result normal?

YES>>

Inspection End.

NO>>

GO TO 4.

CHECK COMBINATION METER

Check the combination meter. Refer to Diagnosis Description.

Is the inspection result normal?

YES>>

GO TO 5.

NO>>

Repair or replace combination meter. Refer to Removal and Installation.

CHECK TERMINAL

  1. Check the combination meter pin terminals for damage or loose connection with harness connector.

  2. Check the parking brake switch pin terminals for damage or loose connection with harness connector.

Is the inspection result normal?

YES>>

Replace the ABS actuator and electric unit (control unit). Refer to Removal and Installation.

NO>>

Repair or replace error-detected parts.

Component Inspection

CHECK PARKING BRAKE SWITCH

  1. Ignition switch OFF.

  2. Disconnect parking brake switch harness connector.

  3. Check the continuity between parking brake switch terminal and ground.

    Parking brake switch—ConditionContinuity
    Terminal
    1 Ground When parking brake switch is pressed Yes
    When parking brake switch is released No

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Replace the parking brake switch. Refer to Exploded View.