Brakes

U1002 System Comm (can)

5steps
~30min
2/5difficulty
Done 0 of 5
DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen item

(Trouble diagnosis content)
DTC detected condition
U1002

SYSTEM COMM (CAN)

(CAN system communication)
Diagnosis condition
  • When ignition switch ON.

  • When power supply voltage is normal.

Signal (terminal) CAN communication signal
Threshold When ABS actuator and electric unit (control unit) is not transmitting or receiving CAN communication signal.
Diagnosis delay time 2 seconds or less

POSSIBLE CAUSE

PAST DTCCRNT DTC
  • CAN communication line

  • Harness or connector

  • CAN communication line

  • ABS actuator and electric unit (control unit)

  • Steering angle sensor

FAIL-SAFE

The following functions are suspended:

  • VDC function

  • TCS function

  • Brake assist function

  • Hill start assist function

DTC Confirmation Procedure

PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF and wait at least 10 seconds before conducting the next test.

>>

GO TO 2.

DTC REPRODUCTION PROCEDURE

CONSULT

  1. Ignition switch OFF.

  2. Start the engine.

  3. Select “Self Diagnostic Result” mode of “ABS”.

Is DTC “U1002” detected?

YES>>

“CRNT” is displayed: Proceed to DTC Diagnosis Procedure.

YES>>

“PAST” is displayed: Inspection End (Erase the memory of “Self Diagnostic Result” mode of “ABS”).

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

CHECK CAN DIAGNOSIS SUPPORT MONITOR

CONSULT

  1. Select “CAN Diagnosis Support Monitor” mode of “ABS”.

  2. Check the malfunction history between each control unit connected to ABS actuator and electric unit (control unit).

Check the result of “PAST”?

>>

All items are “OK”. Check the intermittent incident. Refer to Intermittent Incident.

>>

“TRANSMIT DIAG” is other than “OK”. GO TO 2.

>>

A control unit other than ABS actuator and electric unit (control unit) is anything other than “OK”. GO TO 3.

CHECK TRANSMITTING SIDE UNIT

CONSULT

Check the ABS actuator and electric unit (control unit) harness connector terminals No. 14 and 26 for damage or loose connection.

Is the inspection result normal?

YES>>

Erase the memory of “Self Diagnostic Result” mode of “ABS”. Then select “Self Diagnostic Result” mode of “ABS”.

NO>>

Recheck the terminals for damage or loose connection.

CHECK APPLICABLE CONTROL UNIT

Check the terminals of each harness connector for damage or loose connection.

Is the inspection result normal?

YES>>

Erase the memory of “Self Diagnostic Result” mode of applicable control unit. Then select “Self Diagnostic Result” mode of applicable control unit.

NO>>

Recheck the terminals for damage or loose connection.