Brakes

C1170 Variant Coding

3steps
~18min
2/5difficulty
Done 0 of 3
DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen item

(Trouble diagnosis content)
DTC detected condition
C1170

VARIANT CODING

(Variant coding)
Diagnosis condition When ignition switch ON.
Signal (terminal) —
Threshold When the information in ABS actuator and electric unit (control unit) is not the same.
Diagnosis delay time —

POSSIBLE CAUSE

  • ABS actuator and electric unit (control unit)

FAIL-SAFE

The following functions are suspended:

  • VDC function

  • TCS function

  • ABS function

  • EBD function

  • Brake assist function

  • Hill start assist function

DTC Confirmation Procedure

PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF and wait at least 10 seconds before conducting the next test.

>>

GO TO 2.

CHECK DTC DETECTION

CONSULT

  1. Ignition switch OFF.

  2. Start the engine.

  3. Perform “Self Diagnostic Result” mode of “ABS”.

Is DTC “C1170” detected?

YES>>

“CRNT” is displayed: Proceed to DTC Diagnosis Procedure.

YES>>

“PAST” is displayed: Inspection End (Erase the memory of “Self Diagnostic Result” mode of “ABS”.)

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

CONFIGURATION OF ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)

Perform configuration of ABS actuator and electric unit (control unit). Refer to Work Procedure.

>>

GO TO 2.

CHECK SELF DIAGNOSTIC RESULT

CONSULT

Replace the ABS actuator and electric unit (control unit) even if other DTC are displayed along with “C1170” in self-diagnosis for “ABS”.

>>

Replace the ABS actuator and electric unit (control unit). Refer to Removal and Installation.