Brakes

C1154 Transmission Range Switch

9steps
~54min
3/5difficulty
Done 0 of 9
DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen item

(Trouble diagnosis content)
DTC detected condition
C1154

PNP POSI SIG

(PNP position signal)
Diagnosis condition When ignition switch ON.
Signal (terminal) Shift position signal
Threshold When a malfunction is detected in TCM system.
Diagnosis delay time 2 seconds

POSSIBLE CAUSE

PAST DTCCRNT DTC
  • Harness or connector

  • Transmission range switch

  • Harness or connector

  • ABS actuator and electric unit (control unit)

  • TCM

  • Transmission range switch

FAIL-SAFE

The following functions are suspended:

  • VDC function

  • TCS function

  • Hill start assist function

DTC Confirmation Procedure

PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF and wait at least 10 seconds before conducting the next test.

>>

GO TO 2.

CHECK DTC DETECTION

CONSULT

  1. Ignition switch OFF.

  2. Start the engine.

  3. Select “Self Diagnostic Result” mode of “ABS”.

Is DTC “C1154” detected?

YES>>

“C1154” is displayed as “CRNT”: Proceed to DTC Diagnosis Procedure.

YES>>

“C1154” is displayed as “PAST”: Inspection End (Erase the memory of “Self Diagnostic Result” mode of “ABS”.)

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

CHECK CVT SYSTEM

CONSULT

Select “Self Diagnostic Result” mode of “TRANSMISSION”.

Is DTC detected?

YES>>

Check the DTC. Refer to DTC Index.

NO>>

GO TO 2.

PERFORM SELF DIAGNOSTIC RESULT

CONSULT

  1. Erase the memory of “Self Diagnostic Result” mode of “ABS”.

  2. Ignition switch OFF.

  3. Start the engine.

  4. Drive the Nissan Murano vehicle for a short period of time.

  5. Stop the Nissan Murano vehicle.

  6. Select “Self Diagnostic Result” mode of “ABS”.

Is DTC “C1154” detected?

YES>>

Replace the ABS actuator and electric unit (control unit). Refer to Removal and Installation.

NO>>

Check pin terminals and connection of each harness connector for abnormal conditions. Repair / replace harness, connector, or terminal.