Control Cable

| 1. | Shift selector assembly | 2. | Control cable | 3. | Lock plate |
| 4. | Bracket | 5. | Transaxle assembly | A. | Manual lever |
| B. | Grommet |
REMOVAL
Apply the parking brake.
Remove the front air duct, air cleaner cases (upper and lower) with mass air flow sensor and air duct assembly. Refer to Removal and Installation.
Remove control cable nut (
), using suitable tool.

Remove control cable (1) from manual lever (A).
Remove lock plate (2) from control cable (1).
Remove control cable (1) from bracket (3).
Remove the shift lock override button cover (1) using a suitable tool, and insert the suitable tool into opening (A) to depress the shift lock override button. Move the shift selector to the "N" position while depressing the shift lock override button.

Remove the shift selector handle with the following procedure.Slide the shift selector handle cover (1) down.
Pull out the lock pin (2) from the shift selector handle (3). Pull the shift selector handle and the shift selector handle cover upwards to remove them.
Release shift selector finisher clips and pawls using a suitable tool; disconnect the harness connectors and remove. Refer to Exploded View.
Release center console side finisher (RH) clip and pawls using a suitable tool and remove. Refer to Exploded View.
Position aside the center console lower side finisher (RH). Refer to Exploded View.
Remove control cable (1) from shift selector assembly (2).

(A): Ribbed surface
Pull back dash trim (A) and remove bolts (
), using suitable tool.

Remove the control cable (1) from the Nissan Murano vehicle.
INSTALLATION
Installation is in the reverse order of removal.
When installing control cable (1) to shift selector assembly (2), make sure that control cable is fully pressed in with the ribbed surface (A) facing upward.

Adjust control cable as necessary. Refer to Inspection and Adjustment.
Check CVT position. Refer to Inspection and Adjustment.
If malfunction is found, adjust CVT position. Refer to Inspection and Adjustment.