Transmission & Driveline
Input Speed Sensor
In this manual: Transmission & Driveline
~1min read

| 1. | Input speed sensor | 2. | O-ring | 3. | Transaxle assembly |
| : Apply CVT fluid |
REMOVAL
Remove the battery tray. Refer to Removal and Installation.
Remove the starter motor. Refer to Removal and Installation.
Disconnect the harness connector from the input speed sensor (1).

Remove the input speed sensor bolt, then the input speed sensor (1).
Remove the O-ring (2) from the input speed sensor (1).
INSTALLATION
Installation is in the reverse order of removal.
INSPECTION AFTER INSTALLATION
Check for CVT fluid leakage. Refer to Inspection.
ADJUSTMENT AFTER INSTALLATION
Adjust CVT fluid level. Refer to Adjustment.
Was this page helpful?