Audio / Video

Radio Receiver Power Supply Circuit

~1min read

DESCRIPTION

This is the power supply circuit for operating the radio receiver assembly.

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

Check the fuses for the circuits related to this system before performing the following procedure.

PROCEDURE

  1. CHECK WIRE HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY POWER SOURCE)

(a) Disconnect the radio receiver assembly connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

F48-7 (GND1) - Body ground

Always

Below 1 Ω

*a

Front view of wire harness side connector

(to radio receiver assembly)

(c) Measure the voltage according to the value(s) shown in the table below.

Standard voltage:

Tester Connection

Condition

Specified Condition

F48-4 (+B1) - F48-7 (GND1)

Always

11 à 14 V

F48-3 (ACC1) - F48-7 (GND1)

Ignition Switch in ACC position

11 à 14 V

OK

GO TO APPLICABLE SYSTEM AS INDICATED IN THE PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR