Audio / Video

How to Use Troubleshooting

~2min read

PRECAUTION / NOTICE / HINT

HINT:

Follow the procedure below to troubleshoot the audio and video system.

PROCEDURE

  1. VEHICLE BROUGHT TO WORKSHOP

NEXT
  1. CUSTOMER PROBLEM ANALYSIS

  • When troubleshooting, make sure the symptoms of the problem have been correctly identified. Any preconceptions must be set aside in order to make an accurate judgment. To clearly understand the actual symptoms of the problem, it is essential to ask the customer about the nature of the problem and the conditions under which it occurred.
  • Gather as much information as possible for reference. Previous problems that do not appear related to the current problem may also be very useful in some cases.
  • The following 5 elements are essential for analyzing the problem:

    What

    Vehicle model, system name

    When

    Date, time, frequency of occurrence

    Where

    Road conditions

    What were the conditions?

    Driving conditions, weather conditions

    How did it happen?

    Problem Symptoms

NEXT
  1. CHECK BATTERY VOLTAGE

(a) Measure the battery voltage.

Standard voltage:

11 à 14 V

HINT:

If the voltage is below 11 V, charge or replace the battery before proceeding to the next step.

NEXT
  1. CHECK INTERIOR

(a) Make sure that the conditions for condensation to form inside the cabin are limited and that the temperature there is neither too high nor too low.

OK:

The conditions for condensation to form are limited, and the temperature is neither too high nor too low.

HINT:

  • A humid cabin and rapid temperature changes can easily cause condensation to form. Condensation inside the cabin may cause a short circuit.
  • The audio and video system may not operate normally when the temperature is -20°C (-4°F) or lower, or 65 °C or higher.
NG

PROPERLY ADJUST THE CABIN TEMPERATURE

OK
  1. SYMPTOM TROUBLESHOOTING TABLE

(a) Refer to the Symptom Troubleshooting Table.

Click here

Result:

Result

Proceed to

The malfunction is not listed in the Problem Symptoms Table

A

The malfunction is listed in the Problem Symptoms Table

B

B

GO TO STEP 7

A
  1. TROUBLESHOOT BY SYMPTOM

(a) Refer to the ECU terminals.

Click here

NEXT
  1. CHECK THE CIRCUIT

(a) Make any necessary adjustments, repairs or replacements.

NEXT
  1. PERFORM CONFIRMATION TEST

NEXT

END