Audio / Video

USB Audio System Recognition / Playback Error

~3min read

DESCRIPTION

When a USB device or an "iPod" is connected to the USB connector of the audio system, it must contain playable files. The device must also communicate with the radio receiver assembly and be recognized by it. This diagnostic procedure is performed when a device is not recognized or when the device files cannot be played normally.

PRECAUTION / NOTICE / HINT

HINT:

  • If a USB device contains a large amount of data, playback may take a long time to start.
  • When using a USB device, files that are copy-protected or encrypted for copyright reasons cannot be played.
  • If files are not played in the defined order, follow the procedure below before performing the check.
    1. Add numbers in front of the file names.
    2. Place the files in a folder and copy the folder data to the USB device.

PROCEDURE

  1. CHECK THE USB DEVICE OR "iPod"

(a) Disconnect the USB device or "iPod" from the audio system.

(b) Check whether playable files are present on the USB device or "iPod".

HINT:

Refer to the System Description section for playable files.

Click here

(c) Check whether the format of the USB device is compatible, or whether the version of the "iPod" is compatible.

HINT:

Refer to the System Description section for compatible formats and versions.

Click here

Result:

Condition

Proceed to

No playable files exist, or the device format or version is not compatible.

A

Playable files exist, and the device format and version are compatible.

B

A

END (THE USB DEVICE FORMAT WAS INCOMPATIBLE, THE "iPod" VERSION WAS INCOMPATIBLE, OR NO PLAYABLE FILES WERE PRESENT)

B
  1. FORMAT THE USB DEVICE OR RESTORE THE "iPod" AND CHECK AGAIN

(a) Delete all files on the USB device or "iPod" and format/restore it.

(b) Save the data again and check whether it can be played on the device in the vehicle.

NOTICE:

Formatting a USB device or restoring an "iPod" erases all music stored on the device.

Make sure music backup data is available before performing this operation.

OK:

The malfunction disappears.

OK

END

NG
  1. REPLACE THE USB DEVICE OR RESTORE THE "iPod"

(a) Turn the ignition switch OFF.

HINT:

When this malfunction occurs, the ignition switch must be turned to OFF so the vehicle can recognize a new device when it is connected.

(b) Turn the ignition switch to ACC.

(c) Connect a good USB device or "iPod" to the audio system.

HINT:

  • If the malfunction occurred while a USB device was being used, use a different USB device to perform the check. If the malfunction occurred while an "iPod" was being used, use a different "iPod" to perform the check.
  • Refer to the System Description section for compatible formats and versions.

    Click here

NEXT
  1. CHECK THE USB DEVICE OR RESTORE THE "iPod" AND CHECK AGAIN

(a) Check whether the USB device or "iPod" is recognized by the radio receiver assembly and whether information such as track, artist and album names is shown on the display.

OK:

The malfunction disappears.

OK

THE USB DEVICE OR "iPod" WAS INCOMPATIBLE OR DEFECTIVE

NG

GO TO APPLICABLE SYSTEM AS INDICATED IN THE PROBLEM SYMPTOMS TABLE