Symptom Table
SYMPTOM TROUBLESHOOTING TABLE
HINT:
- Use the table below to determine the cause of the symptoms. If several suspected areas are listed, the possible causes of the symptom are shown in order of probability in the "Suspected Area" column of the table. Check each symptom, verifying the suspected areas in the order listed. Replace parts if necessary.
- Check the fuses and relays associated with this system before checking the suspected areas listed below.
Symptom | Suspected Area | Link |
|---|---|---|
Panel switches do not operate |
Follow the "Panel Switches Do Not Operate" procedure |
|
Follow the "Radio Receiver Power Supply Circuit" procedure |
||
Radio receiver assembly |
||
Panel switch illumination does not operate when the TAIL switch is in the ON position |
Follow the "Illumination Circuit" procedure |
Symptom | Suspected Area | Link |
|---|---|---|
The system cannot be activated using the steering wheel switch |
Follow the "Panel Switches Do Not Operate" procedure |
|
Follow the "Steering Wheel Switch Circuit" procedure |
||
Radio receiver assembly |
||
Steering wheel switch illumination does not operate when the tail light switch is in the ON position |
Follow the "Illumination Circuit" procedure |
Symptom | Suspected Area | Link |
|---|---|---|
No sound comes from the speakers |
Follow the "No Sound from Speakers" procedure |
|
Follow the "Speaker Circuit" procedure |
||
Radio receiver assembly |
||
Sound quality is poor in all modes (volume is too low) |
Make sure the ASL function is turned off |
- |
Follow the "Poor Sound Quality in All Modes (Low Volume)" procedure |
||
Follow the "Speaker Circuit" procedure |
||
Radio receiver assembly |
||
ASL does not operate |
Make sure the ASL function is turned on |
- |
Follow the "Vehicle Speed Signal Circuit Between Radio and Instrument Cluster" procedure |
||
Radio receiver assembly |
||
Abnormal noise is present |
Follow the "Noise Interference" procedure |
|
Radio receiver assembly |
Symptom | Suspected Area | Link |
|---|---|---|
Radio broadcasts cannot be received or reception is poor. |
Follow the "Radio Broadcasts Cannot Be Received or Reception Is Poor" procedure |
Symptom | Suspected Area | Link |
|---|---|---|
CD cannot be loaded/played or is ejected immediately after insertion |
Go to the "CD Cannot Be Loaded/Played or Is Ejected Immediately After Insertion" procedure |
|
CD cannot be ejected |
Follow the "CD Cannot Be Ejected" procedure |
|
Sudden changes in sound while listening to CD |
Follow the "Sudden Changes in Sound While Listening to CD" procedure |
|
Sound quality is poor only in CD play mode (volume is too low) |
Follow the "Sound Quality Is Poor When CD Is Played (Volume Is Too Low)" procedure |
Symptom | Suspected Area | Link |
|---|---|---|
Sound from auxiliary device is not audible or sound quality is poor (stereo jack is used) |
Radio receiver assembly |
Symptom | Suspected Area | Link |
|---|---|---|
No sound from the USB audio system, or poor sound quality (USB connector in use) |
Radio receiver assembly |
|
The USB device or "iPod" is not recognized |
Follow the procedure "USB Audio System Recognition/Playback Error" |
|
Radio receiver assembly |
||
Track information such as track name, artist name and album name is not displayed |
Follow the procedure "USB Audio System Recognition/Playback Error" |
|
Radio receiver assembly |
||
The USB device or "iPod" is recognized but cannot play, or cannot play in a specific order |
Follow the procedure "USB Audio System Recognition/Playback Error" |
|
Radio receiver assembly |
||
"iPod" battery cannot be charged |
Follow the procedure "USB Audio System Recognition/Playback Error" |
|
Radio receiver assembly |
Symptom | Suspected Area | Link |
|---|---|---|
"Bluetooth" does not work (the in-vehicle unit cannot be found by the mobile phone) |
Follow the procedure "Mobile Phone Check" |
|
Radio receiver assembly |
||
The "Bluetooth"-compatible mobile phone cannot be registered |
Follow the procedure "Mobile Phone Registration Error" |
|
The "Bluetooth"-compatible mobile phone cannot be connected |
Check whether the mobile phone is connected as a hands-free device |
- |
Move the mobile phone close to the in-vehicle unit and reconnect it |
- |
|
Follow the procedure "Mobile Phone Check" |
||
Radio receiver assembly |
||
The "Bluetooth"-compatible mobile phone cannot connect automatically (can be connected manually) |
Make sure the "Bluetooth" auto connection setting on the in-vehicle unit is set to ON |
- |
Radio receiver assembly |
||
The "Bluetooth"-compatible mobile phone connection is disconnected |
Move the mobile phone close to the in-vehicle unit and make sure it reconnects |
- |
Follow the procedure "Mobile Phone Check" |
||
Radio receiver assembly |
||
Message prompting to check whether the mobile phone is displayed |
Move the mobile phone close to the in-vehicle unit and make sure it reconnects |
- |
Follow the procedure "Mobile Phone Check" |
||
Radio receiver assembly |
||
When the ignition switch is in the ACC position, instructions for checking the connection conditions between the mobile phone and the vehicle unit are displayed |
Set the mobile phone connection confirmation display to OFF on the in-vehicle unit |
- |
Phonebook data cannot be transferred manually or automatically |
Make sure no application is running on the mobile phone |
- |
When using the "Bluetooth" audio function, disconnect the "Bluetooth" audio player and check operation |
- |
|
Follow the procedure "Mobile Phone Check" |
||
Radio receiver assembly |
||
Phonebook data is erased |
Radio receiver assembly |
|
Phonebook data cannot be edited |
Radio receiver assembly |
|
The mobile phone cannot make/receive calls |
Move the vehicle to an area with mobile phone reception, make sure the "Bluetooth" device is connected to the vehicle, and operate the device again |
- |
Check that the mobile phone can make and receive outgoing/incoming calls correctly when it is not connected via "Bluetooth" |
- |
|
Follow the procedure "Mobile Phone Check" |
||
Radio receiver assembly |
||
The caller's voice is interrupted by noise or sound quality is poor |
Check the voice reception volume (if it is too high, the voice may sound distorted) |
- |
Make a call with the mobile phone disconnected from "Bluetooth" and make sure the caller's voice is clearly audible |
- |
|
Follow the procedure "Mobile Phone Check" |
||
Radio receiver assembly |
||
The caller's voice cannot be heard |
Check that the voice reception volume is not set to minimum |
- |
Make a call with the mobile phone disconnected from "Bluetooth" and make sure the caller's voice is clearly audible |
- |
|
Follow the procedure "Mobile Phone Check" |
||
Radio receiver assembly |
||
Your voice (the caller's side) is interrupted by noise or sound quality is poor |
Check the voice transmission volume (if it is too high, the voice may sound distorted) |
- |
Make sure no object can cause noise at the microphone (air outlet from the air conditioning system pointed at the microphone, wind from an open window, additional devices, etc. can affect noise occurrence) |
- |
|
Follow the procedure "Mobile Phone Check" |
||
Follow the "Microphone Circuit Between Microphone and Radio" procedure |
||
Radio receiver assembly |
||
The other party cannot hear your voice |
When speaking on the mobile phone, make sure the mute button is not pressed |
- |
Make sure no object can cause noise at the microphone (air outlet from the air conditioning system pointed at the microphone, wind from an open window, additional devices, etc. can affect noise occurrence) |
- |
|
Follow the procedure "Mobile Phone Check" |
||
Follow the "Microphone Circuit Between Microphone and Radio" procedure |
||
Radio receiver assembly |
||
"Bluetooth" cannot be connected while the vehicle is moving |
Follow the "Vehicle Speed Signal Circuit Between Radio and Instrument Cluster" procedure |
|
Radio receiver assembly |
Symptom | Suspected Area | Link |
|---|---|---|
The player cannot be registered |
Follow the procedure "The portable player cannot be registered" |
|
Radio receiver assembly |
||
The player cannot be connected manually/automatically |
Follow the procedure "The portable player cannot be registered" |
|
Follow the procedure "The portable player cannot be connected manually/automatically" |
||
Radio receiver assembly |
||
A mobile phone with a portable audio player function is not recognized as a "Bluetooth" audio player even when connected via "Bluetooth" |
Follow the procedure "The portable player cannot be registered" |
|
Follow the procedure "The portable player cannot be connected manually/automatically" |
||
Radio receiver assembly |
||
The portable player sound is not output from the speakers, or the sound is low |
Follow the procedure "The portable player sound is not output from the speakers or the sound is low" |
|
Radio receiver assembly |
||
The portable player does not play, even after selecting the "Bluetooth" audio mode |
Follow the procedure "Does not play even after selecting the Bluetooth mode" |
|
Radio receiver assembly |
||
The portable player does not play |
Follow the procedure "Does not play even after selecting the Bluetooth mode" |
|
Radio receiver assembly |
||
Track information such as track number, track name, elapsed time and playlist is not displayed |
Follow the procedure "The portable player cannot be operated using the onboard device or track information is not displayed on the onboard device" |
|
Radio receiver assembly |
||
Portable player operation keys such as play, pause, repeat and shuffle are not displayed |
Follow the procedure "The portable player cannot be operated using the onboard device or track information is not displayed on the onboard device" |
|
Radio receiver assembly |
||
The "Bluetooth" signal status is not displayed |
Follow the procedure "The portable player cannot be operated using the onboard device or track information is not displayed on the onboard device" |
|
Radio receiver assembly |
||
The pause, file selection, fast forward, fast reverse and shuffle functions of the portable player are unavailable |
Follow the procedure "The portable player cannot be operated using the onboard device or track information is not displayed on the onboard device" |
|
Radio receiver assembly |
||
Sudden sound changes or noise during playback using the portable player |
Follow the procedure "Sudden sound changes or noise during playback using the portable player" |
|
Radio receiver assembly |
||
A registered component can no longer be deleted |
Go to the "A registered component can no longer be deleted" item |
|
Radio receiver assembly |
.gif)