Rear Brake Hose
Components
COMPONENTS
ILLUSTRATION
*1 |
REAR HOSE |
*2 |
GASKET |
*3 |
UNION BOLT |
- |
- |
![]() |
Torque for "Main Areas Related to Basic Vehicle Performance" such as Driving/Turning/Stopping: N*m (kgf*cm, lbf*ft) |
* |
Use with flare nut wrench |
● |
Non-reusable part |
- |
- |
Removal
REMOVAL
PRECAUTION / NOTICE / HINT
HINT:
- Repeat the same procedure for the right side and the left side.
- The following procedure applies to the left side.
PROCEDURE
1. REMOVE REAR WHEEL
Click here
![]()
2. DRAIN BRAKE FLUID
NOTICE:
If brake fluid leaks onto a painted surface, wipe it off immediately.
3. REMOVE REAR BRAKE HOSE
(a) Remove the union bolt and gasket, then disconnect the rear brake hose from the rear disc brake cylinder assembly. |
![]() |
(b) Remove the bolt and detach the rear brake hose from the hose bracket. |
![]() |
(c) Using a flare nut wrench, disconnect the brake tube while holding the rear brake hose with a wrench.
NOTICE:
- Do not kink or damage the brake tube.
- Make sure that no foreign matter, such as dirt or dust, enters the brake tube through the connection points.
(d) Remove the clip and the rear hose from the vehicle body.
Installation
INSTALLATION
PRECAUTION / NOTICE / HINT
NOTICE:
If reusing the rear hoses, use the identification marks made during removal to install each rear hose in its original position.
HINT:
- Repeat the same procedure for the right side and the left side.
- The following procedure applies to the left side.
PROCEDURE
1. INSTALL REAR HOSE
NOTICE:
When installing the rear hose, reduce the twist in the hose.
(a) Install the rear hose to the vehicle body with a new clip. NOTICE: Install the clip as far as possible. |
|
(b) Using a flare nut wrench, connect the brake tube to the rear hose while holding the rear hose with a wrench.
Torque:
Specified torque:
15.2 N·m {155 kgf·cm, 11 ft·lbf}
NOTICE:
- Do not kink or damage the brake tube.
- Make sure that no foreign matter, such as dirt or dust, enters the brake tube through the connection points.
HINT:
- Calculate the torque wrench reading when changing the torque wrench lever length.
Click here
.gif)
- When using a flare nut wrench (lever arm length of 22 mm (0.866 in.)) + torque wrench (lever arm length of 162 mm (6.38 in.)): 13.4 N*m (137 kgf*cm, 10 ft*lbf)
(c) Install the rear hose to the hose bracket with the bolt.
Torque:
29 N·m {296 kgf·cm, 21 ft·lbf}
(d) Install the rear hose to the rear disc brake wheel cylinder sub-assembly with a new union bolt and a new gasket.
Torque:
30 N·m {310 kgf·cm, 22 ft·lbf}
NOTICE:
Correctly install the rear flexible hose lock in the lock hole of the rear disc brake caliper assembly.
2. BLEED BRAKE LINE
Click here
![]()
3. INSTALL REAR WHEEL
Click here![]()
.png)


