Maintenance

Tires And Wheels

~3min read
0408012016020010376N·mlb·ft
Tightening torque found on this page

Components

COMPONENTS

ILLUSTRATION

*A

for steel wheel

-

-

*1

WHEEL ASSEMBLY

*2

WHEEL COVER

*3

WHEEL NUT

-

-

Torque for "Main Areas Related to Basic Vehicle Performance" such as Driving/Turning/Stopping: N*m (kgf*cm, lbf*ft)

-

-

ILLUSTRATION

*A

for aluminum wheel:

-

-

*1

WHEEL ASSEMBLY

*2

WHEEL NUT

Torque for "Main Areas Related to Basic Vehicle Performance" such as Driving/Turning/Stopping: N*m (kgf*cm, lbf*ft)

-

-

Installation

INSTALLATION

PROCEDURE

1. INSTALL WHEEL ASSEMBLY

NOTICE:

  • Only use wheel nuts that are compatible with the wheel. If incompatible wheel nuts are used, the contact surface of the wheel nut and the wheel may be deformed or damaged. This may result in one or more wheel nuts loosening or falling off, even if tightened to the specified torque.
  • Make sure there is no rust or foreign matter on the wheel hub bolts or on the contact surfaces of the wheel, brake disc and axle hub, etc. Clean the contact surfaces and wheel hub bolts if necessary. If the wheel assembly is installed with foreign matter or rust on the contact surfaces, the foreign matter or rust may create a gap. This may result in one or more wheel nuts loosening or falling off, even if tightened to the specified torque.
  • When installing the wheel nuts, clean them with residue-free solvent and make sure the wheel nuts turn smoothly by hand. If the wheel nuts do not turn smoothly, make sure there is no rust or foreign matter, and clean them if necessary. If the wheel nuts still do not turn smoothly, replace the wheel nuts and wheel hub bolts with new ones.

(a) While aligning the wheel assembly with the center of the axle hub, install the wheel nuts by hand.

(b) Temporarily tighten the wheel nuts in the order shown in the illustration.

*A

for wheel hub bolt 4

*B

for wheel hub bolt 5

(c) Lower the vehicle, then fully tighten the wheel nuts in the order shown in the illustration.

Torque:

103 N·m {1 050 kgf·cm, 76 ft·lbf}

(d) with wheel cover:

(1) Install the wheel cover.

Removal

REMOVAL

PROCEDURE

1. REMOVE WHEEL ASSEMBLY

(a) with wheel cover:

(1) Remove the wheel cover.

(b) Loosen the wheel nuts by approximately 90°.

(c) Lift up the vehicle and remove the wheel nuts and wheel assembly.