Electronic Key/Power Door Lock Transmitter Battery
Replace the battery with a new one as soon as it is worn out.
You will need the following items:
- Flat-blade screwdriver
- Small flat-blade screwdriver
- CR1620 lithium battery (vehicles without a smart entry and start system), or CR2032 (vehicles equipped with a smart entry and start system)
Battery Replacement
Vehicles without a smart entry & start system
1. Remove the cover.
To avoid damaging the key, protect the tip of the screwdriver with a cloth.

2. Remove the battery cover.

3. Remove the old battery.
Install the new battery with the "+" side facing up.

4. To reinstall, perform the steps in the reverse order.
Vehicles with a smart entry & start system
1. Press the unlock button and pull out the mechanical key.

2. Remove the cover.
Use a flat-blade screwdriver of the correct size. Do not pry forcefully, as this may deform the cover.
To avoid damaging the key, protect the tip of the screwdriver with a cloth.

3. Remove the old battery.
When removing the cover, if the battery remains hidden because the electronic key module is attached to the upper part of the cover, separate the module from the cover as shown in the illustration to access the battery.
Use a flat-blade screwdriver of the correct size to remove the battery.
Install the new battery with the "+" side facing up.
4. To reinstall, perform the steps in the reverse order.

■ Use a CR1620 lithium battery (vehicles without a smart entry and start system) or CR2032 (vehicles equipped with a smart entry and start system)
- Batteries can be purchased from a Toyota dealer, an authorized Toyota repairer, any reliable repairer, an electrical appliance store, or a camera shop.
- Replace the battery only with the same model or an equivalent model recommended by the manufacturer.
- Dispose of used batteries in accordance with local regulations.
■ If the key battery is worn out The following symptoms may occur:
- The smart entry and start system (on equipped models), the push-button start (on equipped models), and the power door lock transmitter do not operate properly.
- The effective operating range is reduced.
■ Batteries and other small removed parts These parts are small and may cause suffocation if swallowed by a child. Keep out of reach of children. Failure to do so could result in serious injury or death.
■ Lithium Battery Certification
WARNING: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS
NOTE■ To restore normal operation after replacing the battery Observe the following precautions to prevent accidents:
- Always work with dry hands.
The battery may rust due to moisture.
- Do not touch or move any other internal component of the remote key.
- Do not bend the battery terminals.