Maintenance and care

Engine compartment

22steps
~132min
4/5difficulty
Done 0 of 22
Toyota CH-R. Entretien à faire soi-même
  1. Windshield washer fluid reservoir
  2. Engine coolant reservoir
  3. Fuse boxes
  4. Heat exchanger
  5. Engine oil filler cap
  6. Engine oil dipstick
  7. Heat exchanger coolant reservoir
  8. Battery
  9. Radiator
  10. Condenser
  11. Cooling fan motor

Engine oil

Check the oil level with the dipstick, with the engine off and at operating temperature.

■ Checking the engine oil level

1. Park the vehicle on level ground. After warming up the engine and turning it off, wait more than 5 minutes to allow the oil to drain back into the oil pan.

2. Pull out the dipstick while holding a rag underneath it.

Toyota CH-R. Entretien à faire soi-même

3. Wipe the dipstick clean.

4. Reinsert the dipstick fully.

5. Pull out the dipstick and check the oil level while holding a rag underneath it.

  1. Down
  2. Normal
  3. Excessive

The dipstick may differ in shape depending on the vehicle or engine type.

Toyota CH-R. Entretien à faire soi-même

6. Wipe the dipstick clean and reinsert it fully.

■ Adding engine oil If the oil level is below or just above the MIN mark, add engine oil of the same type as that already in the engine.

Toyota CH-R. Entretien à faire soi-même

Before adding oil, check the type of oil to use and prepare the tools you need.

Selecting engine oil
Oil quantity (MIN → MAX) 1.5 L (1.6 US qt, 1.3 Imp. qt)
Items Clean funnel

1. Remove the engine oil filler cap by turning it counterclockwise.

2. Pour in the engine oil slowly and check the level regularly with the dipstick.

3. Reinstall the engine oil filler cap by turning it clockwise.

■ Engine oil consumption A certain amount of engine oil will be consumed while the vehicle is being driven. In the following situations, oil consumption may increase, and you may need to add engine oil between oil changes.

  • When the engine is new, for example immediately after purchasing the vehicle or replacing the engine
  • If the oil used is of poor quality or its viscosity is unsuitable
  • When driving at high engine speeds or under heavy loads, when towing a caravan/trailer, or when frequently accelerating and decelerating
  • When the engine is left idling for too long, or when the vehicle is often used in heavy traffic conditions

■ After changing the engine oil The engine oil maintenance values must be reset. Proceed as follows:

1. Display trip meter "A" with the engine running.

2. Turn the ignition switch off.

3. Vehicles without a "smart key" entry and start system: While pressing the "TRIP" button, turn the ignition switch to "ON" (but do not start the engine, or the reset mode will be cancelled). Keep your finger on the button until the trip meter displays "00000".

Vehicles equipped with a "smart key" entry and start system: While pressing the "TRIP" button, turn the ignition switch to START mode (but do not start the engine, or the reset mode will be cancelled). Keep your finger on the button until the trip meter displays "00000".

WARNING

■ Used engine oil

  • Used engine oil contains potentially harmful contaminants that may cause skin diseases (inflammation and even skin cancer). Therefore, avoid prolonged and repeated contact with used engine oil. To clean skin exposed to used engine oil, wash thoroughly with soap and water.
  • Do not dispose of used engine oil and oil filters carelessly. Do not throw used engine oil or oil filters into household waste, sewers, or directly into the environment.

    For information on collection and recycling, consult a Toyota dealer, an authorized Toyota repairer, any reliable repairer, a service station, or an accessories store.

  • Keep used engine oil out of the reach of children.
NOTE

■ To prevent serious engine damage

Check the engine oil level very regularly.

■ When changing the engine oil

Be careful not to spill engine oil on vehicle components.

  • Avoid overfilling, as this may cause engine damage.
  • Check the oil level with the dipstick each time you add oil.
  • Make sure to reinstall and tighten the engine oil filler cap securely.

Engine coolant

The coolant level is satisfactory when it is between the "FULL" and "LOW" marks on the reservoir, with the engine cold.

■ Engine coolant reservoir

  1. Reservoir cap
  2. "FULL" mark
  3. "LOW" mark

If the level is below or just above the "LOW" mark, add coolant up to the "FULL" mark.

Toyota CH-R. Entretien à faire soi-même

■ Heat exchanger coolant reservoir

  1. Reservoir cap
  2. "F" (full) mark
  3. "L" (low) mark

If the level is below or just above the "L" mark, add coolant up to the "F" mark.

Toyota CH-R. Entretien à faire soi-même

■ Selecting the coolant Use only "Toyota Super Long Life Coolant" or an equivalent high-quality ethylene glycol-based coolant that contains no silicates, amines, nitrites, or borates, and uses long-life hybrid organic acid technology.

Toyota Super Long Life Coolant is a mixture of 50% coolant and 50% demineralized water. (Minimum temperature: -35ºC [-31ºF]) For more information on engine coolant, contact a Toyota dealer, an authorized Toyota repairer, or any reliable repairer.

■ If the coolant level drops shortly after topping up Visually inspect the radiator, hoses, engine coolant reservoir caps, drain cock and water pump.

If you cannot find any leaks, have a Toyota dealer, an authorized Toyota repairer, or any reliable repairer perform a radiator cap pressure test and check the cooling system for possible leaks.

WARNING

■ When the engine is hot Do not open the engine coolant reservoir cap.

Hot, pressurized coolant may spray in all directions if you remove the radiator cap, causing serious burns.

NOTE

■ Adding coolant Coolant is not pure water or conventional antifreeze. The correct mixture of water and antifreeze must be maintained to ensure sufficient lubrication, corrosion protection and cooling performance.

Carefully read the label on the antifreeze or coolant container.

■ If you spill coolant Rinse thoroughly with clean water to avoid damage to mechanical parts or paint.

Radiator, condenser

Inspect the radiator and condenser, and remove any foreign objects.

If any of these components are very dirty or if you are unsure of their condition, have your vehicle inspected by a Toyota dealer, an authorized Toyota repairer, or any reliable repairer.

WARNING

■ When the engine is hot Do not touch the radiator, condenser or intercooler, which may be very hot and cause serious burns.

Battery

Inspect the battery as follows.

■ Warning symbols The meaning of each warning symbol on the top of the battery is as follows:

Toyota CH-R. Entretien à faire soi-même No smoking, keep away from open flames and sparks
Toyota CH-R. Entretien à faire soi-même Wear protective eye goggles
Toyota CH-R. Entretien à faire soi-même Keep out of reach of children
Toyota CH-R. Entretien à faire soi-même Battery electrolyte (acid)
Toyota CH-R. Entretien à faire soi-même Read the handling instructions
Toyota CH-R. Entretien à faire soi-même Explosive gases

■ Battery exterior Check that the battery terminals are not corroded, the connections are not loose, the cables are not cut and the hold-down clamp is securely tightened.

  1. Terminals
  2. Hold-down clamp
    Toyota CH-R. Entretien à faire soi-même

■ Before charging Charging the battery produces hydrogen gas, which is highly flammable and explosive. Therefore, observe the following precautions before charging:

  • If charging while the battery is installed in the vehicle, be sure to disconnect the ground cable.
  • Make sure the charger power switch is off when connecting and disconnecting the cables between the charger and the battery.

■ After charging or reconnecting the battery (vehicles with smart entry and start system)

  • The engine may not start. Follow the procedure described here to reset the system.

1. Shift the shift lever to P (Multidrive) or N (manual transmission).

2. Open and close any one of the doors.

3. Start the engine.

  • Unlocking the doors using the smart entry and start system may not be possible immediately after reconnecting the battery. If this occurs, use the wireless remote control or the conventional key to lock/unlock the doors.
  • Start the engine with the ignition switch in ACC mode. The engine cannot start with the ignition switch off. However, the engine will start normally on the second attempt.
  • The ignition switch mode is stored by the vehicle. When the battery is reconnected, the vehicle restores the ignition switch mode it was in before the battery was disconnected. Be sure to stop the engine before disconnecting the battery.

    Be especially careful when reconnecting the battery if you do not know what mode the ignition switch was in before the battery discharged.

If the system still fails to start after several attempts using all the methods described above, contact a Toyota dealer, an authorized Toyota repairer, or any reliable repairer.

WARNING

■ Battery chemistry Batteries contain sulfuric acid, a toxic and corrosive substance that produces highly flammable and explosive hydrogen gas. To reduce the risk of serious or fatal accidents, observe the following precautions when working on or near the battery:

  • Do not create sparks by touching the battery terminals with a tool.
  • Do not smoke or light matches near the battery.
  • Avoid contact with eyes, skin and clothing.
  • Never swallow or inhale electrolyte.
  • Wear protective eye goggles when working near the battery.
  • Do not allow children near the battery.

■ How to charge the battery safely Always charge the battery in an open area. Do not charge the battery in a garage or enclosed area without adequate ventilation.

■ How to charge the battery Always use a slow charge (5 A maximum). The battery may explode if you try to charge it faster.

WARNING

■ Electrolyte emergency measures

  • If electrolyte gets in your eyes
    Rinse with clean water for at least 15 minutes and seek medical attention immediately. If possible, keep your eyes wet with a sponge or towel while traveling to the nearest medical clinic or emergency room.
  • If electrolyte gets on your skin
    Wash the affected area thoroughly. Seek medical attention immediately if you feel pain or burning.
  • If electrolyte gets on your clothing
    It may soak through the clothing and reach your skin. Remove the clothing immediately and, if necessary, follow the procedure described above.
  • If you accidentally swallow electrolyte
    Drink large amounts of water or milk. Seek medical attention immediately.

■ When there is not enough electrolyte in the battery Do not use the battery if it does not contain enough electrolyte. There is a risk that the battery may explode.

NOTE

■ When charging the battery Never charge the battery while the engine is running. Also make sure all accessories are off.

Windshield washer fluid

Add windshield washer fluid in the following situations:

  • A washer does not operate.
  • A warning message is displayed on the multi-information display. (for models equipped with one)
Toyota CH-R. Entretien à faire soi-même
WARNING

■ When adding windshield washer fluid Do not add washer fluid when the engine is hot or running. It contains alcohol and could cause a fire if it spills onto the engine, etc.

NOTE

■ Do not use any product other than windshield washer fluid Do not replace the washer fluid with soapy water or engine antifreeze.

These products may leave permanent stains on the vehicle's paint.

■ Diluting windshield washer fluid If necessary, you may dilute the washer fluid with water.

Refer to the antifreeze protection temperatures shown on the label of the washer fluid container.