Heater / Air Conditioning

Reassembly

~1min read
01020304050118N·mlb·ft
Tightening torque found on this page

REASSEMBLY

PROCEDURE

1. INSTALL COOLER DRIER (VALEO make)

(a) Using needle-nose pliers, install a new cooler drier onto the modulator.

*a

Modulator

(b) Apply sufficient compressor oil to the O-ring.

Compressor oil:

VC100YF or equivalent

NOTICE:

Make sure that the O-rings and O-ring mating surfaces are free of dust or foreign matter.

(c) Using a T55 "TORX" socket wrench, install the modulator cap.

Torque:

11 N·m {112 kgf·cm, 8 ft·lbf}

*a

Modulator

2. INSTALL COOLER DRIER (DENSO make)

(a) Using pliers, install a new cooler drier onto the modulator.

*a

Modulator

(b) Apply sufficient compressor oil to the 3 O-rings and the mating surfaces of a new plug.

Compressor oil:

ND-OIL 12 or equivalent

NOTICE:

Make sure that the O-rings and O-ring mating surfaces are free of dust or foreign matter.

(c) Using a 14 mm hexagon wrench, install the plug onto the modulator.

Torque:

4 N·m {41 kgf·cm, 35 in·lbf}

*a

Modulator