Toyota Camry Quiz
Automatic transmission / trans

Front differential oil seal (U151E)

In this manual: Automatic transmission / trans
Introduction — 61Audio & visual system — 16Automatic transmission / trans — 19Transmission revolution (ATM) — 1Shift lock system (ATM) — 1Brake — 20Clutch — 10Communication system — 4Cooling — 15Cruise control — 3Drive shaft / propeller shaft — 9Emission control — 8Engine control system — 12Engine hood/door — 7Exhaust — 3Exterior/interior trim — 14Front suspension — 9Fuel — 12Heater & air conditioner — 16Ignition — 8Instrument panel/meter — 7Intake — 7Lighting — 11Lubrication — 16Manual transmission/transaxle — 13Parking brake — 10Power steering — 7Rear suspension — 10Seat — 12Service specifications — 26Sliding roof/convertible — 4Starting & charging — 11Starting system (2AZ−FE)(From July, 2003) — 1Starting system (1MZ−FE/3MZ−FE) — 1Steering column — 6Theft deterrent & door lock — 9Tire & wheel — 4Windshield/windowglass/mirror — 5Back window glass — 1Power window control system — 1Power mirror control system — 1Inner rear view mirror assy — 1Windshield glass — 1Wiring — 1
21steps
~126min
4/5difficulty
0204060801004936N·mlb·ft
Tightening torque found on this page
Done 0 of 21
REPLACEMENT
  1. REMOVE FRONT WHEELS
  2. REMOVE ENGINE UNDER COVER RH
  3. REMOVE ENGINE UNDER COVER LH
  4. DRAIN AUTOMATIC TRANSAXLE FLUID

  5. Remove the drain plug, gasket and drain the ATF.

  6. Install a new gasket and the drain plug.

    Torque: 49 N·m
  7. REMOVE FRONT DRIVE SHAFT ASSY RH
  8. REMOVE FRONT DRIVE SHAFT ASSY LH SST 09520−01010, 09520−24010 (09520−32040)
  9. REMOVE TRANSAXLE HOUSING OIL SEAL

  10. Using SST, pull out the oil seal.

    SST 09308−00010

Remove transaxle housing oil seal
Remove transaxle housing oil seal 8. REMOVE DIFFERENTIAL SIDE BEARING RETAINER OIL SEAL

  1. Using SST, pull out the oil seal.

    SST 09308−00010

Remove differential side bearing retainer oil seal
Remove differential side bearing retainer oil seal 9. INSTALL DIFFERENTIAL SIDE BEARING RETAINER OIL SEAL

  1. Using SST and a hammer, drive in a new oil seal.

    SST 09316−60011 (09316−00011) Oil seal drive in depth: 0 0.5 mm (0 0.020 in.)

  2. Coat the lip of the oil seal with MP grease.

Install differential side bearing retainer oil seal
Install differential side bearing retainer oil seal 10. INSTALL TRANSAXLE HOUSING OIL SEAL

  1. Using SST and a hammer, drive in a new oil seal.

    SST 09223−15020, 09950−70010 (09951−07150) Oil seal drive in depth: 0 0.5 mm (0 0.020 in.)

  2. Coat the lip of the oil seal with MP grease.

Install transaxle housing oil seal
Install transaxle housing oil seal
  1. INSTALL FRONT DRIVE SHAFT ASSY LH
  2. INSTALL FRONT DRIVE SHAFT ASSY RH
  3. INSTALL ENGINE UNDER COVER LH
  4. INSTALL ENGINE UNDER COVER RH
  5. INSTALL FRONT WHEELS
  6. ADD AUTOMATIC TRANSAXLE FLUID Fluid type: ATF type T−IV Capacity: 3.5 liters (3.7 US qts, 3.1 lmp. qts)
  7. INSPECT AUTOMATIC TRANSAXLE FLUID

Test yourself

A quick Toyota Camry quiz: every answer comes with an explanation and a link to the manual page.