Toyota Camry Quiz
Automatic transmission / trans

Transmission control cable assy (ATM)

In this manual: Automatic transmission / trans
Introduction — 61Audio & visual system — 16Automatic transmission / trans — 19Transmission revolution (ATM) — 1Shift lock system (ATM) — 1Brake — 20Clutch — 10Communication system — 4Cooling — 15Cruise control — 3Drive shaft / propeller shaft — 9Emission control — 8Engine control system — 12Engine hood/door — 7Exhaust — 3Exterior/interior trim — 14Front suspension — 9Fuel — 12Heater & air conditioner — 16Ignition — 8Instrument panel/meter — 7Intake — 7Lighting — 11Lubrication — 16Manual transmission/transaxle — 13Parking brake — 10Power steering — 7Rear suspension — 10Seat — 12Service specifications — 26Sliding roof/convertible — 4Starting & charging — 11Starting system (2AZ−FE)(From July, 2003) — 1Starting system (1MZ−FE/3MZ−FE) — 1Steering column — 6Theft deterrent & door lock — 9Tire & wheel — 4Windshield/windowglass/mirror — 5Back window glass — 1Power window control system — 1Power mirror control system — 1Inner rear view mirror assy — 1Windshield glass — 1Wiring — 1
31steps
~186min
4/5difficulty
010203040504.94N·mlb·ft
Tightening torque found on this page
Done 0 of 31
REPLACEMENT
  1. DISCONNECT BATTERY NEGATIVE TERMINAL
  2. REMOVE INSTRUMENT PANEL SAFETY PAD SUB−ASSY
  3. REMOVE AIR CONDITIONING RADIATOR ASSY
  4. REMOVE AIR BAG ECU ASSY
  5. REMOVE AIR CLEANER ASSY
  6. REMOVE INTAKE AIR CONNECTOR SUB−ASSY
  7. REMOVE EXHAUST PIPE ASSY
  8. REMOVE TRANSMISSION CONTROL CABLE ASSY

  9. Remove the 2 bolts and disconnect shift cable grommet retainer No.2.

  10. Remove the nut from the control shaft lever.

  11. Disconnect the control cable from the control shaft lever.

  12. Remove the clip and disconnect the control cable from the control cable bracket.

  13. Disconnect the control cable from the control cable clamp.

  14. Disconnect the floor shift cable from the transmission floor shift assy.

  15. Pull out the control cable from the body.

  16. Remove the shift cable grommet retainer No. 2.

    9. INSTALL TRANSMISSION CONTROL CABLE ASSY
9. INSTALL TRANSMISSION CONTROL CABLE ASSY

  1. Put in the control cable to the body.

  2. Install the shift cable grommet retainer No.2 to the floor shift cable.

  3. Install the floor shift cable as shown in the illustration.

HINT:

  • Install it with the uneven surface facing to up.

  • Fit the claws securely.

  1. Connect the control cable to the control cable clamp.

  2. Install the control cable and a new clip to the bracket.

  3. Temporarily install the control cable to the control shaft lever with nuts.

  4. Install the shift cable grommet retainer No.2 with the 2 bolts.

    Torque: 4,9 N·m
  5. INSTALL EXHAUST PIPE ASSY
  6. INSTALL AIR BAG ECU ASSY
  7. INSTALL AIR CONDITIONING RADIATOR ASSY
  8. ADJUST SHIFT LEVER POSITION
  9. INSPECT SHIFT LEVER POSITION
  10. INSTALL INTAKE AIR CONNECTOR SUB−ASSY
  11. INSTALL AIR CLEANER ASSY
  12. INSTALL BATTERY NEGATIVE TERMINAL

Test yourself

A quick Toyota Camry quiz: every answer comes with an explanation and a link to the manual page.