Installation

NOTICE:

• Never use SRS parts from another vehicle. When replacing parts, replace them with new ones.
• Never reuse the side and curtain shield airbag sensor assembly involved in a collision when the airbag has deployed.
• Never repair a sensor in order to reuse it.

HINT: For step 2 to 9, refer to page BO-101 .

1. INSTALL SIDE AND CURTAIN SHIELD AIRBAG SENSOR

(a) Install the side and curtain shield airbag sensor assembly with the 2 bolts.

Torque: 20 N·m

(b) Connect the connector of the side and curtain shield airbag sensor assembly.

NOTICE:

• Connection of the connector is done after the sensor assembly has been installed.
• Make sure that the sensor assembly is installed with the specified torque.
• If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor assembly with a new one.
• When installing the sensor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other parts.
• After installation, shake the sensor assembly to check that there is no looseness.

2. INSTALL FRONT SEAT OUTER BELT

Torque: Upper bolt: 8 N·m

3. INSTALL CENTER PILLAR LOWER GARNISH

4. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP

5. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP

6. INSTALL FRONT SEAT OUTER BELT FLOOR ANCHOR

Torque: 42 N·m

7. INSTALL LAP BELT OUTER ANCHOR COVER

8. INSTALL FRONT DOOR SCUFF PLATE

9. INSTALL REAR DOOR SCUFF PLATE

10. INSPECT SRS WARNING LIGHT (DI-692 )