Toyota Land Cruiser Quiz
Body Electrical

Removal

In this manual: Body Electrical
Introduction — 13Preparation — 19Service specifications — 19Engine Mechanical — 28Automatic Transmission — 22Body Electrical — 373Brake — 34Propeller Shaft — 7Transfer — 24Motor shift control system — 1Steering — 34Ignition — 7Charging — 9Emission Control — 6Cooling — 17Starting — 12Lubrication — 13Maintenance — 7Chassis — 1Disassembly — 1
~1min read

NOTICE:

  • If the wiring connector of the SRS is disconnected and the ignition switch is at ON position, DTCs will be recorded.
  • Never use SRS parts from another vehicle. When replacing parts, replace them with new parts.
  • Never reuse the sensor involved in a collision when the SRS has deployed.
  • Never repair a sensor in order to reuse it.

1. REMOVE FRONT AIRBAG SENSOR LH

REMOVE FRONT AIRBAG SENSOR LH

(a) Remove the battery carrier and battery.

(b) Disconnect the front airbag sensor connector.

NOTICE: Disconnect the connector with sensor assembly installed.

(c) Pull the windshield washer tank opening as shown in the illustration.

(d) Remove the 2 bolts and front airbag sensor LH.

2. REMOVE FRONT AIRBAG SENSOR RH

REMOVE FRONT AIRBAG SENSOR RH

(a) Disconnect the front airbag sensor connector.

NOTICE: Disconnect the connector with sensor assembly installed.

(b) Remove the 2 bolts and front airbag sensor RH.

Test yourself

A quick Toyota Land Cruiser quiz: every answer comes with an explanation and a link to the manual page.