Toyota Land Cruiser Quiz
Body Electrical

Removal

In this manual: Body Electrical
Introduction — 13Preparation — 19Service specifications — 19Engine Mechanical — 28Automatic Transmission — 22Body Electrical — 373Brake — 34Propeller Shaft — 7Transfer — 24Motor shift control system — 1Steering — 34Ignition — 7Charging — 9Emission Control — 6Cooling — 17Starting — 12Lubrication — 13Maintenance — 7Chassis — 1Disassembly — 1
~1min read

NOTICE:

  • If the wiring connector of the SRS is disconnected and the ignition switch is at ON position, DTCs will be recorded.
  • Never use the airbag parts from another vehicle.

    When replacing parts, replace them with new parts.

1. DISCONNECT AIRBAG CONNECTOR

DISCONNECT AIRBAG CONNECTOR

(a) Remove the glove compartment door.

(b) Remove the No. 1 under cover from the lower No. 2 finish panel.

NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness.

(c) Pull up the connector.

(d) Disconnect the front passenger airbag connector.

2. REMOVE INSTRUMENT PANEL (BO-84 )

3. REMOVE CENTER BRACKET

4. REMOVE DEFROSTER NOZZLE ASSEMBLY

5. REMOVE NO. 5 HEATER TO REGISTER DUCT

6. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT

7. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY

REMOVE FRONT PASSENGER AIRBAG ASSEMBLY

Remove the 3 nuts, then remove the front passenger airbag assembly.

CAUTION:

  • Do not store the front passenger airbag assembly with the airbag deployment side facing downward.
  • Never disassemble the front passenger airbag assembly.

Test yourself

A quick Toyota Land Cruiser quiz: every answer comes with an explanation and a link to the manual page.