Toyota Tacoma Quiz
Brake Control / Dynamic Control Systems

Invalid Data Received from Deceleration Sensor (C1442,C1443)

In this manual: Brake Control / Dynamic Control Systems
Introduction — 15Maintenance — 8Audio / Video — 94Garage Door Opener — 7Navigation / Multi Info Display — 84Park Assist / Monitoring — 86Brake — 50Brake Control / Dynamic Control Systems — 165Parking Brake — 52gr-fks Charging — 252gr-fks Cooling — 212gr-fks Emission Control — 132gr-fks Engine Control — 322gr-fks Engine Mechanical — 332gr-fks Exhaust — 92gr-fks Fuel — 422gr-fks Ignition — 62gr-fks Intake — 72gr-fks Lubrication — 152gr-fks Starting — 38Ac60e Automatic Transmission / Transaxle — 146Axle — 19Clutch — 20Cruise Control — 168Differential — 50Drive Shaft — 6Propeller Shaft — 23Rc62f Manual Transmission / Transaxle — 34Suspension — 22Tire And Wheel — 39Vf2cm Transfer — 44Can Communication — 45Multiplex Communication — 20Power Distribution — 5Power Steering — 29Steering Column — 29Air Conditioning — 108Door Lock — 88Engine Hood / Door — 16Engine Immobiliser — 47Exterior — 55Horn — 5Interior — 18Interior Panel — 8Lighting — 93Meter / Gauge / Display — 31Mirror — 22Other System — 24Pre-collision — 40Seat — 52Seat Belt — 40Sliding Roof — 26Supplemental Restraint Systems — 139Theft Deterrent — 20Window / Glass — 53Wiper / Washer — 24
~1min read
DESCRIPTION

The skid control ECU (master cylinder solenoid) receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via the CAN communication system.

The airbag sensor assembly has a built-in yaw rate and acceleration sensor.

DTC Code

DTC Detection Condition

Trouble Area

C1442

An invalid data signal is transmitted continuously from the acceleration sensor for 10 seconds or more.

Yaw rate and acceleration sensor (airbag sensor assembly)

C1443

An invalid data signal is transmitted continuously from the yaw rate sensor for 10 seconds or more.

Yaw rate and acceleration sensor (airbag sensor assembly)
CAUTION / NOTICE / HINT

NOTICE:

When replacing the yaw rate and acceleration sensor (airbag sensor assembly), perform zero point calibration (See page ). PROCEDURE ).

PROCEDURE

  1. CHECK DTC

(a) Turn the ignition switch off.

(b) Clear the DTC (See page ). (c) Start and idle the engine for 60 seconds, and then stop the engine. ).

(c) Start and idle the engine for 60 seconds, and then stop the engine.

(d) Check if the same DTC is recorded (See page Result Result ).

Result

Result

Proceed to

DTC output

A

DTC not output

B
A

REPLACE AIRBAG SENSOR ASSEMBLY
B

CHECK USE SIMULATION METHOD TO CHECK

Test yourself

A quick Toyota Tacoma quiz: every answer comes with an explanation and a link to the manual page.