Toyota Venza Quiz
Lighting (int)

How To Proceed With Troubleshooting

In this manual: Lighting (int)
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
CAUTION / NOTICE / HINT

HINT:

  • Use the following procedure to troubleshoot the lighting system.
  • *: Use the Techstream.
PROCEDURE

  1. VEHICLE BROUGHT TO WORKSHOP

NEXT

  1. CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK

NEXT

  1. INSPECT BATTERY VOLTAGE

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

NEXT

  1. INSPECT CAN COMMUNICATION SYSTEM*

(a) Use the Techstream to check if the CAN communication system is functioning normally.

Result

Proceed to

CAN communication system DTC is not output.

A

CAN communication system DTC is output.

B

B

GO TO CAN COMMUNICATION SYSTEM
A

  1. PROBLEM SYMPTOMS TABLE

Result

Proceed to

Fault is not listed in Problem Symptoms Table.

A

Fault is listed in Problem Symptoms Table.

B

B

GO TO STEP 7
A

  1. OVERALL ANALYSIS AND TROUBLESHOOTING*

(a) Data List / Active Test (See page ).


(b) Terminals of ECU (See page ).


NEXT

  1. ADJUST, REPAIR OR REPLACE

NEXT

  1. CONFIRMATION TEST


NEXT

END

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.