3-cyl. injection engine, timing belt drive (4-valve)

Air filter

7steps
~42min
2/5difficulty
010203040501.61N·mlb·ft
Tightening torque found on this page
Done 0 of 7

Assembly overview - air filter housing

VW UP. 3-Zyl. Einspritzmotor, Zahnriemenantrieb (4-Ventiler)

  1. Intake hose
  2. Bolt
    • 11 pcs
    • 1,6 N·m
  3. Air filter upper part
  4. Air filter element
  5. Air filter lower part
  6. Rubber mount
    • Make sure it is seated correctly
  7. Sealing ring
    • Make sure it is seated correctly

Removing and installing air filter housing


Note

  • Self-tapping screws are used as standard to secure the upper air filter section to the lower air filter section. If these screws are loosened or tightened with an impact driver, the thread in the intake manifold or lower air filter section can be damaged.
  • For this reason, the use of an impact driver is only permitted if the driver speed is max. 200 rpm and a tightening torque of max. 1.6 N·m is set.

Removing

- Disconnect hose -1- from air filter housing.

- Pull air filter housing upward off the bolts at points -2- and -3-.

- Press air filter housing with intake connection out of mount -4- in -arrow direction-.

- Remove air filter housing from engine compartment.

- To disassemble, unscrew the screws.

Installing

Installation is carried out in the reverse order. Observe the following:

- Make sure the seal is correctly seated.

VW UP. 3-Zyl. Einspritzmotor, Zahnriemenantrieb (4-Ventiler)

- When installing the engine cover, make sure the rubber buffers are correctly inserted into the mounts.

- Make sure the air filter is correctly seated.

VW UP. 3-Zyl. Einspritzmotor, Zahnriemenantrieb (4-Ventiler)