Liftgate
Removal and installation
PROCEDURE

1. Release the window regulator handle clip and remove the handle. The clip is released by inserting a clean cloth between the handle and the door trim and, pulling the cloth back and forth against the ends of the clip, hooking and releasing it. Pull the handle toward you so that, after the clip is released, it slides off the splines of the window regulator shaft.

2. Remove the inside handle screw, then press the handle toward the door hinges and remove it from the door trim.

3. Remove the door trim mounting screws.

4. Insert a door trim remover between the door trim and the door and release the clips.

5. Remove the door trim and lower the window.

6. Remove the screws securing the glass to the window regulator plate.

7. Remove the screws and the bolt securing the rear glass run.

8. Remove the fixed glass from the back door.

9. Remove the movable glass from the back door.

10. Remove the outer door weatherstrip from the back door.

11. Remove the screws and the window regulator. Disconnect the rod from the inside door handle.

12. Remove the door latch and the door lock actuator.

13. Remove the outside handle.
14. Install in the reverse order of removal.
Test yourself
A quick Hyundai Accent quiz: every answer comes with an explanation and a link to the manual page.