Automatic Reverse

If the window detects any obstruction while closing automatically, it will stop and lower approximately 12 in. (30 cm) to allow the object to be cleared.

If the window detects resistance while the power window switch is held continuously in the up position, the window will stop moving up, then lower approximately 1 in. (2.5 cm).

If the power window switch is pulled continuously again within 5 seconds after the window has lowered by the auto reverse function, the window auto reverse will not operate.

Information

The automatic reverse function is only active when the Auto Up function is used by fully pulling the switch to the second detent and holding it.

NOTICE

Do not install any accessories on the windows. The auto reverse function may not operate.

WARNING

Make sure that body parts or other objects are safely clear of the window before closing it to avoid injury or vehicle damage.

Objects less than 0.16 in. (4 mm) in diameter between the window glass and the upper window channel cannot be detected by the automatic reverse function, and the window will not stop and reverse.